1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

What have you done to your Tacoma today? 1st Gen Edition

Discussion in '1st Gen. Tacomas (1995-2004)' started by SlimDigg, Feb 7, 2011.

  1. Jun 29, 2015 at 7:57 PM
    RhettSims

    RhettSims Tacoma4Life

    Joined:
    Oct 29, 2014
    Member:
    #141328
    Messages:
    241
    Gender:
    Male
    First Name:
    Rhett
    Ft Walton Beach, Florida
    Vehicle:
    2004 Red Tacoma TRD SR5 Limited 4x4
    ToyTec Bilstein 3" lift K&N air filter Grey Wire Mod Mickey Thompson Baja Lock 16x8 BS:3.625 BFG KM2 285/75/16 Turn signal/running light swap 2X10 RockfordFosgate P3 1200 Wat RockfordFosgate Prime Amp Regear 4.88 CV boot mod ABR front locker Custom Fabricated bed rack CVT Mt. Ranier High lift 60" Hella FF
    Okay so is there ANYTHING to worry about with actually cutting it off? I've beat it down pretty good but what would cutting it off actually help?
     
  2. Jun 29, 2015 at 8:03 PM
    Blackdawg

    Blackdawg Dr. Frankenstein

    Joined:
    Dec 31, 2010
    Member:
    #48500
    Messages:
    81,591
    Gender:
    Male
    First Name:
    Monte
    Wyoming/St. Louis
    Vehicle:
    The Trifecta of Taco's
    ALL OF THEM!...Then some more.
    I just cut mine off both bodies. Was easier.
     
  3. Jun 29, 2015 at 8:11 PM
    Squeaky Penguin

    Squeaky Penguin Nothing Ventured, Nothing Gained

    Joined:
    Apr 5, 2012
    Member:
    #76340
    Messages:
    10,060
    Gender:
    Male
    First Name:
    Brett
    Steamboat Springs, Colorado
    Vehicle:
    '01 4WD, SR5, TRD & '13 TRDOR AC
    Lots of dust and custom dents, Check Build
    I would be concerned about stuffing a tire into such a ragged firewall.

    The only thing you might do if you cut them off is run some seam sealer, but I ran for over a year without and never had a problem. The undercoating should suffice.

    Oh, might as well leave the dremel on the shelf and grab a grinder too...
     
  4. Jun 29, 2015 at 8:15 PM
    RhettSims

    RhettSims Tacoma4Life

    Joined:
    Oct 29, 2014
    Member:
    #141328
    Messages:
    241
    Gender:
    Male
    First Name:
    Rhett
    Ft Walton Beach, Florida
    Vehicle:
    2004 Red Tacoma TRD SR5 Limited 4x4
    ToyTec Bilstein 3" lift K&N air filter Grey Wire Mod Mickey Thompson Baja Lock 16x8 BS:3.625 BFG KM2 285/75/16 Turn signal/running light swap 2X10 RockfordFosgate P3 1200 Wat RockfordFosgate Prime Amp Regear 4.88 CV boot mod ABR front locker Custom Fabricated bed rack CVT Mt. Ranier High lift 60" Hella FF
    I plan on sanding everything too. So it's not gonna be so ragged. But I reckon I can cut it off and use seam sealer them undercoat
     
  5. Jun 29, 2015 at 9:05 PM
    Deathbysnusnu

    Deathbysnusnu Work is just a daily detour to happy hour.

    Joined:
    Oct 4, 2013
    Member:
    #113825
    Messages:
    17,037
    Gender:
    Male
    First Name:
    Brett
    Fort Crawlins, CO
    Vehicle:
    Vintage Tundra
    Dog, camper.
    ebbs15 and RhettSims like this.
  6. Jun 29, 2015 at 9:21 PM
    alphabravo

    alphabravo Well-Known Member

    Joined:
    Jan 6, 2014
    Member:
    #120082
    Messages:
    1,735
    Gender:
    Male
    First Name:
    Christopher
    Canada via FL
    Vehicle:
    2003 Tacoma TRD
    Supercharger AntiDark Hood Light Redline Tuning Hood Struts Morimoto Projectors Grey Wire Mod Tundra 13WL Brake Conversion EBC ED Pads and GD Rotors Mean Green Starter DC Power 250A Alternator Odyssey PC2150 Battery, Artec Cage ADS shocks Total Chaos UCA ComeUp Winch, Factor 55 Splicer Relentless bumpers OTRATTW Switches, Bussman 15304-2-2-4 RTMR, Paranoid Fabrication switch brackets Jensen JHD3630BT Morimoto XB LED Fogs Deaver Custom Springs Ivan Stewart TRD Wheels, Pro Series TRD Wheels
    Mocked up the Odyssey 31 series battery and the Artec cage. The 1-5/16" thick piece of foam resting on the positive terminal clears the hood without touching.

    [​IMG]
     
    tibblits920 and SWYPER like this.
  7. Jun 29, 2015 at 9:27 PM
    Apex

    Apex Member

    Joined:
    Nov 26, 2013
    Member:
    #117324
    Messages:
    10
    Gender:
    Male
    First Name:
    Ryan
    SoCal
    Vehicle:
    98 Tacoma SR5
    slick man
     
  8. Jun 30, 2015 at 7:16 AM
    cynicalrider

    cynicalrider #NFG

    Joined:
    Jul 25, 2012
    Member:
    #83399
    Messages:
    17,086
    Gender:
    Male
    Jersey
    Vehicle:
    01 SR5 TRD 4x4, '23 Bronco Wildtrak, 2017 HSQV FE350
    Drop bracket lift and booger welds
    Everyones engine bays are always so clean. :anonymous:
     
    SWYPER likes this.
  9. Jun 30, 2015 at 7:42 AM
    SWYPER

    SWYPER Well-Known Member

    Joined:
    Apr 3, 2015
    Member:
    #152442
    Messages:
    162
    Gender:
    Male
    First Name:
    Dylan
    South Carolina
    Vehicle:
    1998 Tacoma 2.7L 4x4
    Finally got my truck back to put on my toolbox, but I cleaned it up a little first. Fits nicely:)image.jpgimage.jpg
     
  10. Jun 30, 2015 at 1:02 PM
    joemauma

    joemauma Well-Known Member

    Joined:
    Jun 26, 2013
    Member:
    #107089
    Messages:
    376
    Gender:
    Male
    Oregon
    Vehicle:
    Double Cab
    That is amazing.
     
    SWYPER[QUOTED] likes this.
  11. Jun 30, 2015 at 4:38 PM
    EastBayTaco

    EastBayTaco Well-Known Member

    Joined:
    Feb 13, 2015
    Member:
    #148589
    Messages:
    130
    Gender:
    Male
    First Name:
    Carlos
    Bay Area, CA
    Vehicle:
    96 Tacoma 4x4 SR5
    OME Everything! (883 coils with Dakars), Light Racing UCAs, Wheelers SS brake lines, Toytec 1" lift shackles, Magnaflow muffler, CKMA12 ARB On-Board Air Compressor, Custom 80' Sliders
    The truck bout to be official now!
    D5179A7E-36E7-4E3E-A4D2-3A9EE6849318_zps_3135057d6be961c1e3b562e88089669b7dd917cb.jpg
     
  12. Jun 30, 2015 at 4:41 PM
    SWYPER

    SWYPER Well-Known Member

    Joined:
    Apr 3, 2015
    Member:
    #152442
    Messages:
    162
    Gender:
    Male
    First Name:
    Dylan
    South Carolina
    Vehicle:
    1998 Tacoma 2.7L 4x4
    I want one of those so bad!
     
  13. Jun 30, 2015 at 5:33 PM
    Fernando

    Fernando Hammerdown

    Joined:
    Aug 25, 2012
    Member:
    #85507
    Messages:
    23,448
    Gender:
    Male
    First Name:
    Fernando
    Sacramento
    Vehicle:
    04 Tacoma DC 4x4
    Too many, See Build
    100 billion dollars! BWWUUUUAAAHHHHAAAHHHAAAA
     
    EastBayTaco and MatthewMay1 like this.
  14. Jun 30, 2015 at 6:19 PM
    LogCabins

    LogCabins Well-Known Member

    Joined:
    Apr 30, 2014
    Member:
    #128878
    Messages:
    2,310
    Gender:
    Male
    First Name:
    Robert
    Oahu
    Vehicle:
    99 SR5 3.4L 4WD
    I got mine in the mail to this week all the way in Hawaii....Huge Mahalo @tcBob
     
  15. Jun 30, 2015 at 6:39 PM
    NDK81

    NDK81 Active Member

    Joined:
    May 3, 2015
    Member:
    #154464
    Messages:
    40
    Gender:
    Male
    Northern NM
    Vehicle:
    97' Taco
    OME Suspension Kit, AFE Filter, Deck Plate Mod 235/85 16 on 16 hole spares.
    I bought my 97' 2.7 4x4 xtra cab auto a 96' 2.7 regular cab 4x4 5 speed for a parts truck. 109k and only $700. The bad? Rusted through broken frame on the 96'. Pics and 5 speed swap this weekend!
     
  16. Jun 30, 2015 at 7:08 PM
    westhumboldt

    westhumboldt Well-Known Member

    Joined:
    Nov 5, 2014
    Member:
    #141778
    Messages:
    224
    Gender:
    Male
    Arcata,Ca
    Vehicle:
    97 Tacoma sc 4x4
    Doug Thorley headers, urd 7th and Trd Supercharger, bilstein lift, trd locker just installed.
    where did you buy the battery cage?
     
  17. Jun 30, 2015 at 7:24 PM
    Squeaky Penguin

    Squeaky Penguin Nothing Ventured, Nothing Gained

    Joined:
    Apr 5, 2012
    Member:
    #76340
    Messages:
    10,060
    Gender:
    Male
    First Name:
    Brett
    Steamboat Springs, Colorado
    Vehicle:
    '01 4WD, SR5, TRD & '13 TRDOR AC
    Lots of dust and custom dents, Check Build
    Got my Viair 400H mounted.

    IMAG1120_zpsordhthdy_b488b9c9b2c8394e7a673e401659bae81f21b9b1.jpg
     
    opteron likes this.
  18. Jun 30, 2015 at 7:33 PM
    MatthewMay1

    MatthewMay1 I'm an amateur professional.

    Joined:
    Nov 21, 2011
    Member:
    #67486
    Messages:
    11,102
    Gender:
    Male
    First Name:
    Matthew
    Lone Star Republic
    Vehicle:
    Supercharged '01 TRD
    OBA?
     
  19. Jun 30, 2015 at 8:09 PM
    Squeaky Penguin

    Squeaky Penguin Nothing Ventured, Nothing Gained

    Joined:
    Apr 5, 2012
    Member:
    #76340
    Messages:
    10,060
    Gender:
    Male
    First Name:
    Brett
    Steamboat Springs, Colorado
    Vehicle:
    '01 4WD, SR5, TRD & '13 TRDOR AC
    Lots of dust and custom dents, Check Build
    What exactly do you mean with making that a question? Yes, that is a compressor, but for now, no tank or anything else.
     
    bayareataco likes this.
  20. Jun 30, 2015 at 8:21 PM
    alphabravo

    alphabravo Well-Known Member

    Joined:
    Jan 6, 2014
    Member:
    #120082
    Messages:
    1,735
    Gender:
    Male
    First Name:
    Christopher
    Canada via FL
    Vehicle:
    2003 Tacoma TRD
    Supercharger AntiDark Hood Light Redline Tuning Hood Struts Morimoto Projectors Grey Wire Mod Tundra 13WL Brake Conversion EBC ED Pads and GD Rotors Mean Green Starter DC Power 250A Alternator Odyssey PC2150 Battery, Artec Cage ADS shocks Total Chaos UCA ComeUp Winch, Factor 55 Splicer Relentless bumpers OTRATTW Switches, Bussman 15304-2-2-4 RTMR, Paranoid Fabrication switch brackets Jensen JHD3630BT Morimoto XB LED Fogs Deaver Custom Springs Ivan Stewart TRD Wheels, Pro Series TRD Wheels
    ebbs15 likes this.

Products Discussed in

To Top