What Have You Done To Your 2nd Gen Tacoma Today?

Husky Liners X-act Contour Floor Mats | Fits 2012-2015 Toyota Tacoma, Double & Access Cab; 2012-2014 Toyota Tacoma, Standard Cab | Front Row, 2-pc Black - 53701

http://www.amazon.com/Husky-Liners-53701-X-act-Contour/dp/B00GWFKT26

They're awesome.

They do in fact cover the dead pedal.

 

Those look great. When my OEM mats get too old, I'm definitely picking these up.

 

Avs bug deflector

All Pro UCA's

OME coilovers w/884's and no spacers

Going to ride it around as is for awhile and see if I want to do the add a leaf or not. Alignment tomorrow and then I'll hit the highway looking for vibrations.

 

Pics with the 884s? I just got some for me.

 

This is the best I could do tonight so not very good, literally just got done 40 minutes ago. Waited for the heat to subside and lost daylight.

First one is still light out but drivers side still stock. Second is both sides done and using a small spotlight to hit the front wheel well. I'll post some better ones in the morning or afternoon.

 

Can't wait. Looks great even in the dark!

 

Replaced the front pads and rotors -

Before -



After -



I got 70k miles out of the factory brakes -

 

Change the oil in my transmission to MT-90. It went good, got the drain and fill bolts removed and a nice steady stream without a mess into my drain pan. Then a massive gust of wind blew that steady stream right into my face and gave me a gear oil bath

On a positive note the MT-90 really quieted down my transmission. My 1st gear light throttle take off rattle is gone and the gear box is in general quieter.

 

what are the pinch points??

 

The side panels of the cab and the base panel are pinched and spot welded together.

They aren't very noticeable if the trucks have steps or sliders, otherwise you can see them pretty easily.

 

Changing the trans fluid already on a '14? What is the scheduled interval anyway? How many miles do you have? Also, on a '14 you shouldn't have a trans rattle. I'd be taking it right back to the dealer.

 

After a long while, I finally bit the bullet and got the Bilstein 6112s and 5160s through Headstrong Off-Road! So far so great!

 

Looks good!

 

Not enough bikes in the after pic lol. Does look good though, how do you like the ride?

 

No idea what the actual interval is, but I've got 17400 on it now. Rattled/clattered from day 1 on light take off or being lugged in 2nd, pretty common noise that I only noticed at the toll booth or coffee drive thru. Redline MT-90 is pretty much done at 25k, so I'll change it around 40k again. The 6MT is pretty noisy but no where near as bad as the transmission in my Mustang was.

 

The ride's great so far. Haven't taken it off-road yet, but on the rough streets of L.A., it's soaking up the bumps nicely. Planning on taking out to Mojave in the coming weeks.

 

Oh, and you mentioned bikes?

 

Not done today, but finally took a picture of her after tires and lift. Lift was done few weeks back: bilstein all around with eibach coils and aal in rear, about 2.5-2.75 lift front. Tires are bfg ko2 285/75 r16 only rub uca at full turn. New wheels hopefully soon.

 

Quick morning shot. Leveled out nicely

 

Filled up with gas and cleaned the windshield.