What Have You Done To Your 2nd Gen Tacoma Today?

If u were closer i'd take some animals, my kids would go nuts!!

 

Can you really fail inspection for any of those things? If so that's rough in PA

 

Where in Alabama is the putt putt place?

 

Why do southerners call it putt putt

 

because you're putting. It's not miniature golf, there are no 5 irons, 2 woods, etc.

 

Because there is an entire business down "south" call Putt-Putt fun and Games...

 

I understand a 2 year old calling it putt putt, but a grown man...

 

Every time I hear my brother in law say putt putt I cant help but laugh!!

 

most UK and commonwealth countries call it putt-putt...

 

They also call shopping carts "buggies."

 

And a hoods "bonnets"...which is kinda fitting if you're calling it a hood...but bloody hell.

 

And a hoods "bonnets"...which is kinda fitting if you're calling it a hood...but bloody hell.

 

shopping cart = trolley

and its ALUMINIUM!

 

elevator = lift
apartment = flat
trunk = boot

I could go on

 

The goal was to get the blinker effect on the HALOs, and have them cut off when the headlights come on. I'm sure there is a way, just haven't dove into it yet. May have to go out with the multimeter and see if another smaller resistor on the fastwr of the two would help

 

Pop and Lock added to my 2015 Access Cab 2WD Taco. Put a tonneau cover on last week and realized the tailgate doesn't lock. Literally took longer to remove the tailgate panel than it did to change the lock.

 

Damm my flash is terrible.

 

Or he could always tap into a switched ignition source. I have my halos power wire hooked up to a switched relay under the hood. It's the same relay that you would use for the anytime fog light mod.

 

I put my license plate and frame on with antiteft stainless hardware, and plugged the front bumper cover holes the dealer screwed their plate frame into. Supposed to have a front plate on, but I've left mine off the 01 for years, and haven't had any problems yet, so doing the same on this truck.

Installing nylock nuts behind the bumper...bit of a bitch with that flange hanging down in the way and the hitch and not lowering the spare. Had to use ye old electrical tape to hold the nut in the open-end wrench trick...

So I'm a step closer to mall rated today.

 

I put my license plate and frame on with antiteft stainless hardware, and plugged the front bumper cover holes the dealer screwed the frame into. Supposed ot have a front plate on, but I've left mine off the 01 for years, and haven't had any problems yet, so doing the same on this truck.

Installing nylock nuts behind the bumper...bit of a bitch with that flange hanging down in the way and the hitch and not lowering the spare. Had to use ye old electrical tape to hold the nut in the open-end wrench trick...

So I'm a step closer to mall rated today.