SilverSeven's build up

I thought that was Camden.

 

Good point

 

Are you planning on doing your rear bed like that?

 

yeah, when wamu goes to $12 I will be doing this.

 

everytime i come around your city...

pinky ring worth about 50....

 

are you keeping your 6inch lift i could use one of those impacted bars if your going to sell i bent one of mine up pretty good

 

hey man the whole kit is sold sorry.

 

ah well i guess ill give pro comp a call and see how much they want to rape me

 

wish i could get some specs on those arms... i'd build some super beefy replacements.

they just look like their out there waiting to get tore up.

 

All you need is a measurement. they just rods with bushings at either end. If you remind me i can take on for you when the kit is off

 

yea i could unbolt the side thats not bent and see what size it is from hole to hole but im not sure if the holes will line back up due to one side being bent

 

yea i would have to have a VERY accurate measurement from center to center on the mounting bolts, and also have to know the diameter and width of the bushing and size bolt that holds it in..

i'm curious to know what wall thickness those tubes are... probably not much.

 

yea they look pretty weak im guessing less than 1/8 inch

 

yea i was thinking if i get some measurements maybe make some out of 3/16 wall square tubing... that would be hella tough and should hold up to just about anything you can throw at it....

 

yea... i wonder how close the procomp and fabtech kits are when comparing those arms.... wonder if its close enough that they could both run the same arm or if they would have to be different...

 

actually if i remember right the bolt to the crossmember not the frame rail so i would assume they would have to be close to the same length... but that also limits how far forward or backwards you can move them.

 

yep you got it they are on the crossmember so its pretty much how they are bolted up to the kit i think they should be real close