Long Travel BS Thread

I thought Solo was doing Tundra rack swaps?? Is that not holding up either? May be worth a call to ask them?

 

they are, I was going to have them do the swap on my truck but never found the time to get my truck over there this summer. I'm going to put another OEM rack back in and roll with that for now, on 37s too...

Cost to floss, I'll end up dropping in a Howe 3.0 before I waste the money on more factory Toyota Parts

 

If you get a howe rack in your truck you better show us how you did it haha.

 

Of course, I had really good luck with my last OEM rack so we will see how well this new one holds up to the 37" RTs I'm putting on but the Howe rack will be the next jump should it come to that. Just have other priorities at the moment and I'm not sure how much longer I'm going to be keeping my truck

 

3 more years so I can graduate college and buy it

 

-rear frame boxing + another crossmember
-cam tabs
-coil buckets
-spindles

thats pretty normal.

 

Finished up mounting these roadrunner bedsides, here are some pics and info since I couldnt find shit about them before I ordered. I didnt want to mount them myself because of my bad experience with the last set of bedsides but these were so damn easy. The passenger side was even easier and both sides had minimal trimming needed (basically none). Dont mind the missing driver side tail light, I need to get the bolts for the tail lights (anyone know the size???)

Pics:

 

haha I doubt it will be that long. I really want to get into something I can actually go race and not just a cool prerunner. A couple friends and I have been throwing the Trophylite idea around again lately or I have always wanted to get into a 1600 car. Pros and Cons to both, its all about $$ at this point

 

Every truck is for sale. When you are ready, and have the bank roll.... just ask the owner how much they want.

 

this

 

Quick question for you guys. I know some of you run a stud kit for your wheels. Im getting Method double standard. Would I have to also upgrade to a stud kit for these wheels or can I run stock studs and lug nuts. If I have to upgrade which lug nuts do I get for this wheel? Thanks.

 

ARP Lexus IS300 Extended studs and Open end ET 6 point Lugs

 

Thanks buddy!

 

Thx man. Suggestions on where to buy? I have spindles already.

 

Spindle gussets

TC Cam Tab Gussets
TC Coil Bucket Gussets
TC Spindle Gussets

 

I shouldve done all the gussets already, now one of the cam tabs broke off without me even going on a trip lol

On another note, does anyone want/need some beat up tail lights for free? The tabs are broken so I had drilled screws straight into plastic on the tail light, I think one of them has a cracked off piece of glass but they do work if anyone needs them if you're in a bind

 

Anyone want to go to Ocotillo or Johnson Valley in November? I'll be on leave and still want to experience it before throwing down.

 

Always down for Ocotillo trip, post up when you are going.


Nice little truck for sale

http://sandiego.craigslist.org/csd/cto/5187416986.html

 

I straightened mine out and flattened one driving from the alignment shop to my house (3 mile trip)