Delta's 2002 Tacoma 4WD Build and BS

Damn making me jealous!

 

I need something like that, almost t boned so many people with these brakes

 

Almost rear ended somebody is what made me get these ha

 

Wish I had the space to do it, but not yet ha

 

Ha yeah, and now you have all that wiring coming. And hood struts! You need a mod day haha.

Hows that bumper coming along?

 

I know hopefully soon, uh all that wiring is gonna kill me. But bumper wise not sure yet, I need to ask ha

 

I havent had the most luck with wiring my new halos. I keep on blowing the voltage regulator so im down a halo. Thats something i need to dig into.

That bumper is going to look sweet though! Whats your rim BS?

 

I hate wiring, but everything is kinda a plug n play.

Ha thanks I can't wait honestly!

Uh 4 if IIRCO

 

Ha i do do, luckily my dad loves to do wiring projects.

 

Hopefully it's easy enough that it's a plug and play type set up

 

Good Morning!!! I put my new OME suspension on last night. I got the 881 coils with a the trim packer to prevent the lean. Basically the same set up everyone else has. However I am getting a popping noise from the front when going over bumps and a bit of clunking from the rear braking or shifting from drive to reverse. I am guessing the later might be some drivetrain noise. I am going to ride it out for couple of days & check the torque of all the bolts. Then see if the noises are still there. Did you run into similar pops & clunks after installing your setup?

 

Dang, no I didn't get that many noises. The only noise I got was when I first took it out an the U bolts were still finding their position and moving around a bit. Upfront the clunking can be due to the sway bar bushings being worn out. The rear sounds a bit like axle wrap to me... What is your setup out back?

 

Why has this not crossed my mind...?

 

I'll check the sway bar out this evening when I pull it into the shop. The clunk is definitely a axle wrap
issue. It continues to cause the drive shaft to clunk at the center support bearing. I had to bring that rear diff forward in order to get the leaf springs installed. Did you have to move the rear diff forward as well?

 

A piece of advice, throw the sway bar out. It'll ride a bit better

 

I had to move the diff forward about and inch and a half. I want to get relocation plate but as of now i really dont have a need for it.

X2, took mine out and the smaller bumps in the road feel a lot better now. I dont even notice body roll anymore.

 

I need some weight up front to make it work better since the Eibachs are 620#. But it rides better without, never really noticed a difference in the turns

 

That bumper just needs to get to ya quicker! I noticed it for about the first day, then i forgot i even took it off.

 

Did you get a chance to do your brake swap?

 

Started it but then ran into an issue with the driver side caliper, the place where the copper washer mounts had a deep gouge in. The copper washer couldn't seal up because of that and brake fluid was leaking. I now have new calipers coming to me.