+SconnieHailer's Build & BS+

Are you running the TC shock tower gussets?

 

Nope

 

Nope.

Too much flow for my little na motor haha and no unless you want to pay for it

 

I was curious how the fit would be if you did...

 

Yea I think they just straight up wouldn't ha

 

Everyone I have seen on here with the combo has got them to fit, but Gadget knows of a few that couldn't and it is listed on their site that they won't fit. Probably just depends on how bend your shocktowers are when you install the headers. haha

 

Good point. I'll maybe do those after the headers are on and trim them to fit

 

little NA motor?

whach yoou talkin bout willis???

also..helllll no am i paying for it haha Frank needs boost

 

Just bend the shock towers out away from the engine before you put the gussets on

 

whatever, we can make them fit.

 

Skids are off. Ugh I should clean and repaint these too while they're off... Gonna need some bashing with the bfh to go back on lol! Bolts were tight getting off. Probably going to change trans fluid too while they're off. Woo so much to do!

 

Well loved those skids.

 

They have lots of experience! Headed out to get some Hi temp copper seal for the heads and then I'll be ready to tackle this tomorrow. Gonna go shoot some sage grouse tomorrow morning with jax but they're going on tomorrow no doubt.!

 

you been training him on bird stuff?

 

Yep. Bumpers with old wings tied to them are his fav!

Nekkid and ready for molestation!

 

Glam shot. These look so good! I'll get some good pics of the install tomorrow with the good camera. Plugged the middle runner o2 port since I'll be using the bung down at the collector.

 

Here's a video from a while ago, and though it is with an 18" magnaflow and not the current 22" it can serve as a good before sound clip. I did get some video today but all you hear is tire noise and fan noise... the 22" is quiet.

Funny, the truck looks goofy without the plate bumper re watching this video!

http://www.youtube.com/watch?t=36&v=E2q_-sugy1c

 

Header one is out... This job sucks! Haha!

 

It is a pain in the ass getting them out. I was lucky enough to do it up on a lift. Would not want to have to do it on the ground.

 

This job is easily the most cramped hand space. And screw the o2 connectors. Spend 10 min on the driver's side getting it unclipped. Making progress, bout to put the driver's side on.