What have you done to your Tacoma today? 1st Gen Edition

Dibs on front diff w/ arb

 

It's a rear diff

 

$100 but I'm not shipping

 

You're killing me man.

 

Hmmm I may be interested in the coils. How many miles on them? They are rate for 2 or 2.5 inches of lift?
Also what are you planning on replacing Lola with?

 

When ya gotta go, ya gotta go!

 

Little did I know my tank was already cracking and it caved in all to easily when I applied the slightest amount of pressure on the neck

 

Got my second alignment after my initial lift/suspension install with my 1yr unlimited milage alignment from Sears. Its a good thing, theh said it was off. Man this thing is like butter down the hwy now.

 

If I remember right, they have about 20k on them. Not sure how much lift they'll give over stock. I'll see if I can find my old measurements.

I bought a 2015 4Runner Trail yesterday. I'm picking it up Tuesday evening.

 

I did some off roading for the first time all year. It was a jeep event in Iowa. I got 3rd place in the off road vehicle show out of over 100 jeeps and a few others. I also beat the piss out of my skid plates, but they are still holding up fine. Nothing broke, so they did the job, as expected.

 

Ummm. Yeah...


That looks pretty well banana-ed to me

 

What brand of H4 conversion lights are those?

 

Still works just fine...

 

yeah mine is ready to fall apart too. i thought maybe i let it freeze.

 

I'd still call that a failure. Looks like it is touching your cat, and how much closer is it now to your transfer case. What will it look like the next time you hit it?

Those skids need an actual rear crosmember and some reinforcement. My shit hasn't bent:



But I digress, not like anyone has told you that before....

 

That's my muffler, which is irrelevant since it always touched because it's huge compared to a cat. And the skid was bent long ago when I jumped onto a rock. But it still works a year later. And as usual I don't care what you think.

 

Finally finished the Tundra Brake 13WL upgrade!

 

Sorry, I should have been more specific. The DieHard Platimuns come in various sizes/groups with varying capacities and such. Is yours a group 35?

 

Just finished replacing ujoints and carrier bearing. After today, I've learned I need to start adding 4+ hours on the eta set forth by any write up on TW. Went in expecting a couple hours of work, finished 4 hours later...

 

2 jaw puller and a cut off wheel make easy work of them.