AZ Classifieds

that's what I asked him. sent him a PM with all the info and what I need.

 

I PMd him as well this morning, but it says he hasn't been active since 04AUG. Let me know if you hear from him?

 

@Moose1988 I have the interface software for mapping the MAF Cal. Let me dig it up and I can send it to you

 

Can I get that too? Im grabbing myself the URD MAF Cal I found on CL.

 

Yeah. PM me your email address

 

No I wasn't under any warranty when I did it and I also never took it back to the stealership once I drove it off the lot. The thing is the limited amount of space you have to work in, it's very cramped there are a lot of wires and their all so tiny. I did notice a slight difference when I installed the URD maf and TCAI I also noticed a slight difference when I took everything off. All I did to remove it was untape the wires where I had soldered clip the wire then tape it back up.

 

Does anyone here have the Toyota software to change OEM settings like seat belt and door alarms?

 

not sure about the 3rd gens.. but there's a way to turn off the seat belt chime on 2nd gens with a combination of ODO button presses and buckling your seatbelt.

 

Pretty sure I have a set of aftermarket ones I'll prob never use.
I forget the brand but they are a common brand.
I used them once for a light bar a few years back. I can dig them out if you want them?

 

I could give it a shot if I could find the procedure.

 

one sec...

EDIT: https://www.tacomaworld.com/threads/disable-seatbelt-warning-chime.38842/#post-638348

 

it only works on 08 models?

 

no. I've used this method every time I reset my Battery. Try it on yours. Not sure about 12+.

 

Will they work for a 2gen? 07

 

Don't see why not. They are adjustable.

 

They are Saris. Look real close to these. Not sure which model mine are. Also I doubt I still have the key to lock them. $150 for both.
http://www.rackattack.com/product-pages/saris-901-base-roof-racks-50.asp

 

Will try it, thanks!

 

Didn't work for me.
I have push button start but still tried it.
It goes through some kind of procedure where it shows 5 dots, then 4, 3,2,1, then nada.
I asked the dealer to do it and they said no due to liability issues.

 

This didn't work on my 11. I just removed the speaker.

 

On my 11, I unplugged one wire under the seat. Sounds sketchy, but there is a write up here that tells which wire. I think it was for a ground switch.