switch??

on the trd tacomas where the switches are on the left side of the wheel when you pop out the cover there is a cable what is that connected two? its next to the other switches there is three covers on the bottom

 

It's to any number of things....A locker, or the inverter, or clutch start cancel...

Which blank EXACTALY did you pop out and look behind??

 

the second 1 on the bottom and i have a sport so i dont have a locker i was wondering if its so you can easly run aftermarket lights

 

Clutch interlock safety switch override. lets you start your truck while in gear. (manual transmission only)

Note: Believe Toyota uses the verbiage now of "Clutch start cancel".

 

there is no switch its just a thing with i believe 3 holes

 

Well, naturally you will not have a switch there because you have an automatic transmission and thus do not require the switch.

 

Yeh no switch because you don't have that option if you don't have a manual trans. The wiring harnesses for certain models are the same so even if you don't have the feature, you get the wiring for it.

About running aftermarket lights you can easily install your own switch and wiring in these blanks with little trouble.

 

do you know of any sites that explain the wireng well because i have no idea how to cennect it to the battery

 

I would run new wires from the fuse block for whatever project your attempting. You can use any of those blank switch areas to mount switches, it is however a bad idea to try and alter the wiring in that circuit as it still may be tied to the ignition circuit. Better off running a new line from the fuse block, to a switch (or power relay) then to whatever your trying to run - winch,lights,air compressor, etc.

 

Might want to check out the lighting forum here lot of good advice and a few posts I commented on I know have what will at least get you started. I'll post again later but right now I'm on my iPhone and away from my main pc. You can also PM me or post around if you have any specific questions.

 

thanks can you put up a link of of the wirings i would need thanks

 

Here is one way...it is a sticky in the Technical forum.

http://www.tacomaworld.com/forum/technical-chat/6525-diy-wiring-after-market-lights.html