Black switch spot, Need a fog switch to fit in here!

Hi guys,

Looking to add fogs lights to my SR and i decided I'm going to add a switch instead of buying the new stalk for the steering wheel. Wondering if there is a OEM switch and wiring harness I can buy that will fit in this blank.

I appreciate the help guys!

 

Try this link: http://www.aironboard.com/online/

 

Following along for the ride. I want to do the exact same thing.

 

they have toggle switches that can fit in there.

also, those round switches the size of a nickel with the LED light indicator

 

I was thinking a center console one from a 2nd gen should work!!!

 

I already purchased theretrofitsource XB fog lights from @TRSAndrew on the group buy and got 26% off! Picked up the lights for $132.80 shipped!!!

 

I believe that switch you found there is a little too big cause the blank in my truck meastures 34mm x 24mm which is 1.33" x .94".

 

I also want to do the same thing. I installed fog lights and the switch in a 2007 Tacoma. It was an easy job. Wiring harness, and switch came with the fog lights. For my 2016 Tacoma SR, I need to find fog lights that will fit properly. I'm sure in time they will be offered as an aftermarket kit.

 

Just purchased these this morning Dave!
https://www.theretrofitsource.com/c...to-xb-led-fog-lights-toyota.html#.Vk4vB3ZY5Bc

Group buy going on them now you can get them for $132.80 shipped to your door priority mail!
https://www.tacomaworld.com/threads...deadline-11-23-15.397357/page-7#post-11162870

Ends this monday 11/23/15!

 

I got two that fit the smaller holes from TundraParts.com. There websit has changed quite a bit since then, so you'll have to dig.

Here's a short thread on the subject: https://www.tacomaworld.com/threads/any-ideas-for-additional-switch-locations.301635/

 

I don't want to sound like an idiot, but how do you get the black coverings off where the fog lights are to be installed? Also, what holds the fog lights in place?

 

No question is a dumb question Dave!
Reach down behind the bezel and there is 6 clips like this and it pops right off!

Here is what it looks like without the bezel in. I test fitted a light from a 2nd Gen and it works!

 

Thanks for the info. Will give it a try. Looks like it may be easier than I thought.

 

Your welcome man, it's super easy! Just reach down behind there with one hand an pop the clips the same time as your pulling on the front with the other hand!

 

Not yet, going to do some research later, headed bowling now!

 

The small AOB switches will fit to the right of your steering wheel while the larger switches will fit on the panel to the left of your steering wheel.

 

So my hole on my 16 is the same as the holes on the center below the radio on the 2nd gens.

 

http://www.ebay.com/itm/OFFROAD-ARS...ash=item2edff79313:g:w-8AAOSw7aBVJBm4&vxp=mtr

just double check the measurements before you buy, this seller on ebay has a few options

 

Hey chet,
Could you measure one of those center switches for me. Mine measures 34mm x 24mm just to make sure they are the same. Thanks man!

 

That switch looks a tad small cause my hole measures 34mm x 24mm.