Florida B.S. Thread

Shoot yeah bro I'm gonna miss it. I can leave you a key to the boat ramp if you want though. The resident boat ramp is a stone's throw from bird island. If you get there early enough the gate to the ramp might be open. Bad thing is that it might be closed when you get back. If you don't want the key you could always try the Keene point boat ramp

 

How hard is it to install 5100s with the maxtrac spindles already on? Do I have to take the hubs and brakes off of them?

I know to do it I need a spring compressor.

 

Take lower ball joint off and have at it. If your running a sway bar still need to move that out of the way

 

6112's installed on the first setting witch is .95 on Bilstein's 4x2 chart and it actually raised the front end 2.0 inches. The trucks about level. Happy with the results. The ride is great. I'll drive it a bit and see if it settles and get a alignment.

 

I don't have matrix spindles so can't help ya there. No need to remove the brakes I would think.

 

Ok, Thank you

 

Yea now I realize that wouldn't make sense, haha

 

Safety is the main thing! We just finished mine this morning and my new set up was pre assembled . Careful compressing the coils.

 

My goodies are here.

 

Looks good Jim! Sorry I didn't get back to you on the PM

 

Thank you! It's a busy time of year bud! No worries.

 

Definitely is! getting some overtime in this week since I'll be out all next week

 

Killer @Hugopreston any reason you didn't get the big decal on the spoke..? Every time I see these, I fall in love with them a bit more...

 

Those f5s are sick.

 

I wasn't sure about the bigger decals but the more I think about them the more I dig them. I can always order them in the future if I decide to change it up.

 

I was thinking of going with the SR8 but those F5s are growing on me. I like the simplicity.

 

3 hours to go and it's slow as heck

 

An animal ripped my duck inside out last night and over the last few months took 5 chickens, time to take care of this