Raleigh North Carolina and surrounding areas

I think the stud sticks out just under 1.25 so if use 1" the stud stick out pass spacer .25 and hit rim

 

so pretty much spacers use your existing studs to mount, and then the wheel/tire mounts specifically to the spacer?

 

Yea the spacers bolt to stock studs then spacers have new studs that the tire mounts too

 

SpiderTrax are the best for Tacomas

 

yeah i noticed a lot of people running them

 

Big part being there great hubcentric ring to make sure all lines up great

 

Maybe I'm missing the boat, but I've never had hubcentric spacers on my Tacoma, or older Toyota's. I've never had an issue. Just get all the lug nuts tight.

 

For me there nice, my steel wheel fits right on and stays in place. Also think its a big help for someone who is new to messing with rims and spacers

 

You tell me

 

I won't make it.

 

Tim is this where you ran your led bar wires for your switch?

 

I used the factory fog wires for my LED Bar but yes that's where they go through.

 

Yeah I already used those wires for the pods so gonna run a switch to the cab.

 

When is mod day? I want to get a bed lights, hood lights, and new rock lights. I could use a hand wiring. Would also like a fuse block.

 

2016 1st Mod Day! Er'ybody plan on it

 

Specifically the 'nipple' where the small cable(hood latch?) goes though.

Get in my thread. You're up the Mtn aren't you? https://www.tacomaworld.com/threads/nc-local-small-batch-bussmann-5relay-10fuse.400458

2016, when?

 

I got .75.. Fixed my rubbing issue with 285's.. Well made it better at least.

 

@PreRunnerSeth This should work, right?

 

No, The resistor in series with the LED is there to limit current. Usually about 20mA or so for that size LED. That current will change based on the Voltage. 20mA will most likely not be enough current to close the relay.