Firearm BS thread

Bullhidebelts.com

/thread

 

this happened today!

 

Nice! Did you go off prints or from a complete lower? I've been wanting to do this but in .308.

 

New holster for my g26 Zorn skinny rig

https://www.zornholsters.com/gun-holsters/skinny-rig

 

yes, off prints. the first three in the top photo are 308..

 

Do you mind sharing?

 

I don't think it would be a problem, let me ask my dad.

 

Outfitting an m4 for my job and considering optics. I know I want magnification as I will be using angle sights for CQB. ACOG is obviously a go-to, but I can't justify spending that $$$. Any of you out there have any experience with any optics, good or bad, with magnification?

 

Thanks, I'm not selling/profiting off of it, just want to make one for myself.

 

Rough end mill.

https://youtu.be/WPhB0_lmz9o

 

What about a red dot with a magnifier?

 

I'll be honest, it looks like you were running rather slow for aluminum

 

Not sure if it fits your idea of budget but I have a vortex spitfire 3x that I really enjoy. Clear optics, can illuminate the reticle, and the reticle is etched into the glass so if your battery goes dead you aren't SOL.

 

picked up a Vortex Strikefire 2 (I think that's the name) for my 10.5" build.

 

A buddy of mine sent this too me, swears it's real. Not sure if it is or not but it is pretty Damn funny. I wouldn't doubt it...anyway I thought it was funny.

 

^^^^ROFLMAO^^^^^^

 

Wow could that be legit? It would take a real idiot to not realize his barrel is blown.

But it doesn't look blown, unless the part they cut out is what blew.

 

is that length of brass colored solids the 15 rounds all fused together behind the squib round?

 

Squibs are my biggest fear. I let my brother load a few rounds once cause he was interested and loaded one without powder. Wasn't watching close enough. He was the one shooting when it went through too and thank god the bullet didn't go far enough and the next round wouldn't load.

 

I did this with my first batch loaded on a progressive. Getting the timing down on a new press takes a lot of tweaking sometimes, and a couple snuck in with no powder. I can tell you that a 110 gr 300 blk bullet propelled only by a primer won't go down the barrel far enough to let the next one chamber, thank goodness.