The Pirhett Ship BS Build

Yes sir I follow you lol. My ig name is Pirhett too

 

Good morning gents quick question, how do you make a signature with a linked picture?

 

Like that ^

 

Yep! And I'll take your shell and swing out too

 

Highlight the picture then select the the paper clip looking thing and apply link. Done and done.

 

Just dropping this here. Click on picture for event page.

 

Dam man I would love to go but I'm going to New York for a week :/
And thanks for the help on the signature!

 

Hey guys anyone know if there is a way to hook up some led pods to the original fog light harness and switch? When I get my new bumper it would be nice becuase one less thing to wire.

 

Pretty sure I've seen others do this and I've found plug and play harness conversions on ebay. I'd look into how much power the oem setup can put out vs how much the new lights need. Post up what you find, I need to get my pods installed as well.

 

A buddy of mine is going to wire my bumper pods to the factory fog light switch and circuit if I get my lights by Tuesday

 

I'll post later

 

Thanks guys! I'll do some diggin of my own too

 

Anyone of you guys in SoCal made a ECG, custom cargrill, or BP fab grill yet? I need some help with getting the mesh glued and fitted correctly :/ I cut as much as required maybe more and still can't figure it out. Please help

 

Finally getting around to doing my grill the right way, tip for you guys who want to do a custom car grill or ECG grill tape off the edge of the mesh where it's about to show through. That way you don't worry about over spill, just peel the tape after the glue has already kinda hardened.

 

Following up, after letting the auto goop dry for 2 hours out of the 24 needed to cure I took off the tape on the back side of the grill. Here are some pics to show how the lines of glue are smooth and straight. I did the tape method to prevent glue from going every where and you'll notice in the pic that I have tape on the other side that way if glue does somehow go to the front then it won't affect the face of the grill. If that makes sense
In the second pic the white part of the glue is where I pushed it back after it dried a little so it won't be noticeable through the front.

 

Got the girl finished but Idk why it won't fit flush?

 

Also anyone know a place other than rigid to get light bar amber covers

 

Should I do amber pods in my bumper like this
Or white pods and white bar? Or Amber bar?