3rd Gen White Tacomas - Post them up!

Nice looking truck there, cctk2.

 

First new truck and first Toyota about week old gas mileage is Great compared to the frontier I had before

 

265/70/17 cooper sst pro on TRD 17x7 wheels. Stock suspension.

 

How is the level with the kit? My 3/1 Procomp left the rear fender 1" lower then the front fender. Did yours settle to level after a bit?

 

This just sold me on the DCLB. Now to find one. Bikes look like they fit nicely back there. Great looking truck.

 

Hey, any chance you're looking to unload that s2000? In New Hampshire here and I've been looking for one.

 

That's a mens 26 inch and a womens 29er and both have the front wheels ON
we usually lay them down but we strapped them in to play around in the mud. One bike has to lay on top of the other so they would have been bouncing around on each other
thank you

 

Love this super white. Perfect shade of white.

 

Traded my 13 AC 4x4 2.7L today for the 16 DCLB 4x4 sport. Rims & tires gets installed next week.

 

So no lift? Did you get rubbing fixed?

 

Lifted 3 inches. And yes alignment fixed the rubbing

 

What lift do you have and do you recommend it? My LB will be delivered Friday. Pumped. Have NV's with 285/70/17 Toyo AT2's already haha

 

I have 5100 bilsteins and 887x emu coils. And a Deaver aal. Lr UCA's

 

got my truck at putnam too!

 

The 887x emu coil rides good?

Is your range of travel good or better than stock?

What setting/notch are 5100's?

Would a full leaf replacement ride better in your opinion or would it not be worth it?

The truck looks awesome and is just the right height.

You measured hub to fender and how much lift did it give you?

 

The coil rides fine. Went on very early so I didn't have much stock driving to compare it to. shock set at .85. Did not get 3 inches with the shock at 0. I don't have hub to fender measurements.

 

whats your set up?
lift?
tires?
wheels(i know they are stock, what yr)
did u use any spacers on the wheels for clearance?

 

So...If I get any Bilstien 5100's for a 2005+ Tacoma and set at .85 setting in front, add any Old Man Emu coils I should be able to get 2-3" lift in front?

The 885 series coil will be what I need length wise and also if no bumper or winch, will provide the best ride on street?

What leaf pac will give a level ride with above setup? I think I'd like the full leaf pack replacement, but if it is a waste as far as a good ride will one add a leaf work?

LR is what company? I have heard of Total Choas UCA's. Want the best for suspension travel and droop.

Top spacer thing required? Don't know its purpose.

I have Method NV's and Toyo AT2's in 285/70/17 already.

Thanks I think I am getting close to what I need, thanks to everyone here, especially RIDEZ!!!!

 

I just installed this setup today, except with 887 springs. The truck already had a spacer lift so I wasn't able to get stock measurements but after the 5100s set at .85 and the 887's with a deaver single aal in the back, hub to fender measurements were 24 1/8 in the front and 24 in the back.

We also installed icon upper control arms and did do the top plate spacer on the driver side which is to correct the "tacoma lean".

I'd say if you're not going to add bumpers or armor, the 885s will be just fine.

As for a full leaf pack replacement, that's going to depend on your intended use. If it's primarily a street truck, just do either the icon progressive add a leaf or the single deaver aal. Of course this is just my opinion, but unless you intend on adding a bunch of weight in the back of the truck, like a bed rack or rtt, the full pack replacement is over kill and will give you a harsh ride


Oh and LR is Light Racing. Decent uca's that a lot of people have at good luck with but if you can stomach the cost, icon, tc or camburg would be the way to go