Post your BLACK 3rd Gens

I've had it just over a week and I love it!

 

46k for 2wd?

 

2WD SR5. You can get a limited with lots of extras for that much. They're out of they're minds.

 

It must be a mistake. They are probably asking $34K and the girl posting it online made a typo. Or so I hope. lol

 

Love the lift/tire set up! Great looking Taco! Access cab ftw!

 

What are you guys using on your tires? Armor All?
They look so clean.

 

I use 303

 

Better than Armor All? I just read reviews and it sounds pretty good.

 

Using those two words on this board should come with an automatic 2 week banning. Use 303 or pretty much anything other than what you just said.

 

LOL. I didn't know those two words were that bad. Lesson learned.

 

That stuff is for people who like shiny stuff with no concern for how it (doesn't) protect their vehicle. Stay away from it. Nobody wants shiny dashes and tires anyway. Or do you ? It has no UV protection or anything else that's good for your plastics and vinyls. Use Aerospace 303 on all that stuff, interior and exterior of your truck. It protects and leaves a nice finish without a cheap looking shine.

 

I don't want shiny stuff. I am more concerned with a nice finish and protection.
303 it is then.

 

I've used Armor All on my Honda, which I put 150K miles on and the dash was without cracks. My Acura has 252K miles on it, not a crack anywhere. Nothing wrong with Armor All, except it attracts lots of dust, dirt. However, when I get the 2016 Tacoma, 303 it will be.

 

Not like it will make your dash disintegrate, or anything... unless you use it frequently. haha But it sure isn't helping prolong the life of your vehicle nor does it leave a nice looking finish. But to each their own.

 

@e108132004 Where did you get that piece you attached the bottle opener to?

 

He linked this to me on a previous page:

$24 Te-Co 41406T Black Oxide 1018 Steel Tapped Through T-Slot Nut, 3/8"-16 TPI, 5/8" Height x 7/8" Width x 9/16" Table Slot (Pack of 5)

http://www.amazon.com/gp/product/B0...rue&ref_=oh_aui_detailpage_o04_s00&pldnSite=1

 

That piece i made it my self, i work in a machine shop. They have some pre made on Amazon the problem was that it was 3/8-16 thread. The bottle opener i use has a 1/4-20 hole. http://smile.amazon.com/gp/product/B009SWGLHW?psc=1&redirect=true&ref_=oh_aui_detailpage_o04_s00

 

Did you use Plasti Dip on the grille or paint, looks really nice