Long Travel BS Thread

I dont think its threaded on some of them, iirc mine had the same problem and it just had to be gripped and pulled down

 

I've tried pulling on it. It's set up for a spanner wrench - which would mean it's threaded I would think. Going to keep pulling on it.

 

Put 50 PSI back in and it came right out. Thanks!

 

No problem man

 

Does anyone run bypasses outside the frame with a tundra axle? I think they will rub my tire...I really wanna get rid of the bar across the bed so I can load dirt bikes easier ..still haven't decided on a easy way to get then outside the frame

 

Just dropped off the truck at Solo Motorsports for their 1st Gen XLT 4x4 race kit. 4-6 weeks and she will be ready to rip!!

 

I run my bypasses outside the frame with a Tundra axle.

 

Cannot wait to see it

 

Does the tire rub?

 

I just went full chub

 

No rubbing.

 

Did you use 3/16" plate ? How close was the shock to the frame?

 

Figured it out, nevermind.

 

you will have to cycle the suspension and see if it will rubs at full gnarticulation

 

It's been a while since I read this. I don't remember if he has a tundra axle. Just a little something to look at.

 

I just don't know if there would be enough support with the center tube gone

 

Glad to hear that cause trying delrin has been on my mind lately but I'll stick to what we currently have. In video you can see the engine flex a bit but nothing too bad. Beefed up the frame rail area this last time around enough to get us thru the Mint. Engine will likely come out again this summer and at that point I may redo everything in the area for piece of mind.

 

For anyone on the central coast in California: where's a good spot to get my alignment checked out in the 805 (Santa Barbara/Santa Maria)? Truck is long travel so I want to know that they know what they're looking at (because I'm obviously not good at it).

 

Ian's tire did mine but they only set the toe because I did the camber/caster myself...drives perfect

 

mine rubs but very rarely, and i have 1-1/2 inches from the frame but i can suck them in closer without a problem and then have no rub