IS IT POSSIBLE

width will be your problem, not diameter

 

I may have hit the cab mount with a sledge but they clear it by about 1/8-3/16 trust me though I am going to be doing the CMC and I have the Toyo Open country AT. Correct me if I am wrong but these may be just a RCH short of a true 33" tire

 

what do you want to see? there are some good pics in my media gallery but she is dirtier than fawk right now from all the mag chloride and salt being thrown on the streets...

 

Do you have the stock rims with 33"

 

appears so

 

Nice so what is the exact size you have(tire)?

 

Here you go bud it's like 32.9" by 11.25" roughly

 

Haha, your ass is hangin over the abyss!!

OP, you can fit that set up no problem, there are plenty of people on here that have done it... with some trimming. I would definitely trim the Cab mount and some plastic on the inner side of the flares. Every tire is just a little different so unless someones got the exact compliment of tires and wheels you plan to get, it won't matter what anyone else has because your setup will be different. For example my 285 75 16 are actually a bit over at 33.2. I took a sawzall to my cab mount and still have yet to weld them up even though I've got the plates to do so sitting in my truck. That was two years ago. Inner flares I've trimmed a few different times because that's just the way it goes. you keep trimming until you don't hear any rubbing anymore.

 

Alright man nice truck and do you have a wheel spacer too

 

my last setup I did 1.5in spacers, I ran stock steelies, but only 265's, but I was trimming the inner flares with that combo. My current setup no spacer but 285's 16x8 wheel with a 4.5 backspace.

 

I am running the 1 1/4" spacer currently but will get rid of that just as soon as I get new wheels with the right offset.

 

ok i'm going to argue everyonehere i ran 275/70/17 on my 2013 had to remove the bottom plastic trim piece right in front of the front tire. i was running a 2.75 inch front lift with a 2.75 inch rear with 1.25 in spacers on front only and stock rims. the only time i rubbed was when fully turned while hitting a pothole or something. i ran it through mud holes alot without scraping or rubbing at all but mind you thats with 275/70/17 which is a 32.8/10.8/17 inch tire close to the 33/10.5/17 you're wanting to install

 

Most of us are saying he can run his wanted set up with out problems with minor fixes...

 

False, 275/70R17 is 32.16"