What Have You Done To Your 2nd Gen Tacoma Today?

Installed a 31.5" LED light bar yesterday.

 

Did you install this yourself?

 

Been looking to do something like this. What bar did you go with. And how did you end up mounting it?

 

@ERMB hey, going to buy some 1D6 stuff from them. Did you buy the spray can trigger tool? If so, is it single use, or can you clean and reuse?

 

https://youtu.be/p1LO6uxy11I

 

Soldered in some new brushes and polished up the contact area on my alternator
316,000 and still going

 

I bought my trigger long time ago from lowes probably 7 -8 years ago. They can be used over and over until the trigger wears out. They are attached by a expandable snap ring. They pretty much all function about the same with minor adjustments to the nozzle angle on some models.

 

I'm not running spacers at all just the rim helps has a -6 offset

 

I'm not running spacers at all just the rim helps has a -6 offset

 

Took it out in the rain

 

No wheels spacers man the rims makes them stick out like that... Size of the rim is bigger than stock

 

Nice!

 

I went with a cheap Amazon bar. I sealed it up with black silicone to make sure that no condensation would build up inside the light. I will see how long this bar lasts, if it does not last I can easily replace with a nicer one.

I used these brackets, they worked great!
http://www.realtruck.com/ici-light-mounting-brackets/R183909P2011Y608MA.html

 

Did you paint that section of the bumper as well? I really like that!

 

New headlights, Skid plate and Grill. And a wash

 

Debadged Tail Gate And Ordered The Bullaculla Trailer Harness Relocation Bracket.

 

Its actually just the raw plastic with no paint. I got into a accident a few weeks back and when they painted the replacement bumper, they masked off the bottom section for that look. My original bumper had the same look using plastidip

 

Finished up my tailgate carrier and homemade hc bumper build.

 

Looks good

 

I just got my 1 year service today and waxed it.