PrInSu Design Studio Roof Racks BS Thread

What are those bolt/nuts called in the picture above

 

They are an eye nut screwed onto a carriage bolt that is captive in the tracks.

 

Just ordered a Toprac 5' bed for my ABS tonneau cover. Has anyone mounted one of zach's racks to a tonneau cover using Thule/yakima tracks or something else as a track system? Maybe Aluminum extrusion with T-slot? Similar to what Zach uses for crossbars but smaller. like 1"x 1" or 1" x .5" . I have searched but have not found anyone that has done this.

 

Zach,

Not sure if you can answer this question or have already answered it before, but do you happen to know the minimum distance between the top of the Caprac crossbars and the top of the topper roof? I ask because I'm interested in seeing if I can get a camping table mounted on the underside of the rack to conserve space on top for other goodies.

 

Each cap is going to vary, but mine only has 1.75" of space in the middle of the cap.

 

Thanks fellas. Perhaps I'll have to abandon that idea and instead just strap a roll top table to the rack. Would have been rather handy if that would have been the case!

 

Hey Zach, Do you know the AMP rating on the 40" Heretic bar?

 

They are 200 watts (5 watts per bulb, 40 bulbs on the 40") so assuming a steady 12 volts the amp draw is about 16.67 amps.

 

Gotcha thanks! I just placed a order for my Switch-Pros setup and wanted to make sure!

 

What ever happened with this group buy? If there is still interest in it throw me down. Been looking at these for awhile and ready to pull the trigger, they look great, just not sure if my pockets have that much left to give.

 

GB is in pending status and will start late February. Check out the Group Buy forum. Get your requests in now so he can get everything going and there will be minimal wait.

 

Has anyone mounted a shirt box toprac to a long box topper? Or I should ask what are the lengths on the short and long box topracs?

 

Short bed is 56" and long bed is 65"

 

I figure if anyone would know it would be you guys! Anyone know the bolt size that fits the the weldnuts on the roof?

 

Super excited bought me a 40 inch single row led light bar and wiring harness! Ready for the roof rack!! Come on end of February!

 

Hey Zach, how do I get my hands on a pair of those heretic light bar mounts? I bought my bar before they were offered!

 

Finally got my rack on yesterday!

 

sweet rig

 

Send me an email and I will get you some.

 

Got the rack today! Hopefully the weather will behave and allow me to install it this weekend! Really wishing I had seen the eye nuts at the time of order though. It was probably my mind telling me not to go browsing the website more so I don't spend more...