What Have You Done To Your 3rd Gen Today?

I love thiss! How much did the horns cost if you don't mind me asking?

 

Just for that front little cap!?!?

 

All stock in the rear, just leveled up front.

 

All stock in the rear Heepspo. Yea, I don't think Schwabies installs 5100s but don't quote me on that. Took it to a local off-road shop in town.

 

Stock coils, had the 5100's installed at a local shop, my guy there said it's around a 1.25" raise in front. Nothing added in rear. A lot of guys are being able to squeeze the 265/70/17 without any lift or leveling without rubbing, but I like the look and added clearance the leveling gives up front.

 

Avid bolt on sliders.

 

How much did it cost you ? The parts and install?

 

I believe it's like $100 usd. Check out http://www.diazfabrication.com/ or send a message over to @Andres
Really great quality piece.

 

(2) blistein struts, mount and balance of new tires/wheels, labor + alignment = $525

 

Looks awesome!! More pictures please

 

Not bad ! I'm gonna go ahead and do the same to mine .

 

Appreciate it! I pick it up tomorrow and will take some more over the weekend. Will have the Prinsu w/ 40" light bar included.

 

Outstanding!

Thanks for sharing
= ]

 

Emblems are available at Diazfabrication.com

PM me for a discount code

 

Finally got my wheels in!
Boss 2.0 lift with UCAs
285/70/17

 

My baby just arrived last week.i'm loving it. the only thing that bothers me its the engine ticking at idle, but if its normal i'll get used to it)))




I already did few things :

Raptor series 4 inch nerf bars
Led interior lights
weathertech mats
Katzkin Leather---installed myself (for everybody thinking that its very hard, its not .just takes 8 or 9 hours)

waiting on:
backflip fibermax and sr black grille.

 

OK so I would consider myself to have above average mechanical ability. I have driven Ford trucks for the last 25 years but I have always wanted a Taco. Well this is my first one. For the most part I absolutely love it. Little smaller than the F150 I traded in for this but I also used to drive a Ranger so I am used to the size already love. The MPG is not as listed but when are they (I have a heavy foot) still love it good pick git up and go, great. My point I like light the brighter the better which finally gets me to my point. What in the *&^# are they thinking about these map lights! I bought super bright leds. I have worked those stock slick as oil bulbs for a half hour. I have duct tape sticky enough that woman could use it instead of waxing. I wrapped the ends of needle nose pliers with this mentioned duct tape and it is still slicker than a snot in a bowling ball. I can not believe how shitty some of these should be simple things are engineered. Done venting thanks for listening.
~Still in the dark

 

The easiest way its to remove the whole console and do it from the top.its holded by only 4 clips .just pull hard down in the corners

 

Nice job, seats are beautiful. Not sure about your ticking. Can I ask you where you got your covers from?