2nd Gen 4x4 35s 3" Lift w/o BODY LIFT

No idea, looking at it I realized I cut then sanded so that makes up for the half inch so I'm at 2" off on the flares

 

You need to configure your tool so that your cut pieces coming off are 2". If that red thing on your tool is what is sliding on the edge of your fender, measure 2" from the edge of the red wheel to the center of your pen.

 

Did you tape them up good? That will also help some when cutting

 

Didn't see that til after, all are complete now and smooth. Tomorrow I'm doing the fenders. So general consensus for the fenders is 2" as well?

 

I would go 2.25" that's what I'm doing atleast

 

Good idea, did you have pics of how to mount the flare after the fender is cut?

 

Should just go back in stock clips

 

Are you planning to cut flares off the top? I don't see how they would in mine since the clips are gone now :/

 

What you mean off the top?

 

I'm confused lol I don't see how the stock clips will work since when you cut the flares, the places where the clips were get cut off

 

Shit idk haha. I thought the clips was higher up to the top

 

They are goign to be hanging on by the top clips that are left.

 

Aha! I see now I am an idiot

 

That's another reason why it's good to cut at least 2" off. So you don't have a heavy flare hanging on by only the top clips.

 

I greatly appreciate everyone's help, thank you!

 

What does everyone do about the inner fender liner? I went through the first 25 pages so far

 

Take that shit out

 

Good idea!

 

Exactly why I keep telling everyone a slow speed jig saw is the best tool to use. A slow speed jigsaw will not heat up the blade and melt the plastic and leave a really clean cut.