1st gen skids by RAT Products! I'm back! Cheapest ever!

I will send out requests next week.

 

You don't do 2nd gens? Cmon man

 

Roger that

 

ya had me up in until you don't do 2nd gens!!

 

@Milota95

 

I have some in the works. Coming up next after these ship.

 

Me want/my checkbook hurts

 

Good to hear! I'm in the process of deciding which ones to order. Thanks.

 

Can I get a fuel tank skid added to mine as well? Also in 3/16"

 

Well then...good thing I upgraded to Tundra brakes. And since I am currently not planning on bumpers (always leave an out), it'll probably be just fine.

Put me down for the 3 piece 3/16 as well!

 

Updated.

 

Ryan, I'm trying to decide between 1/8 & 3/16. It's 1/16th" difference. Is it that big of a deal? Can you use a floor jack in the center of the skid on either? I'm always hauling my camper, would you think it's necessary to go for the 3/16th? I want to make sure I'm ordering the correct parts that fit my situation best, thanks!

 

Do you like to bounce off/over rocks? 3/16". Or are you more-so driving down fire roads, wooded trails, and paths that don't scrape bottom a lot? 1/8". It's hard to tell what anyone would actually need, so you have to decide based on how you see yourself using your truck. If your stock skid isn't beat to piss, you probably don't need 3/16". I don't know.

I jacked on my 3/16". I don't recommend doing it because that isn't what they are designed for, but I guess it does work.

 

Cool, I'll update my order to the 3/16ths please.

 

Updated.

 

I would like 3/16th for a 3rd gen 4runner left a comment on t4r but havent got a reply.

 

Updated!

 

I'm interested in the 3/16" 3 piece set with angle iron reinforcement and 3/16" fuel tank skid for my double cab. I need to take measurements on where my BAMF bolt-on slider brackets are at. I want to make sure they're compatible with little/no modifications before I place an order.

Just to confirm, if I'm about 14" or more from my transmission crossmember, I should be good right?

 

@RAT PRODUCTS Looks like I may need to go with the rack coverage skid or notch the transfer case skid to make it work. Any chance you have these measurements (hard to see but the orange arrows in the pic below)? I'm assuming the extra cab and double cab have the transmission crossmember in the same location.

 

Also interested in these exact numbers.