Long Travel BS Thread

I know but since I'm under there I better bite the bullet and get a se of his mounts. Online the are 100 bucks for both then I'll plate/gusset them

 

just emailed tim at dmz to see what hes got

 

Just spend the money on Ryans mounts and get either famous fab perches or the dmz perches.

 

thats the plan

 

Went up this little access road near my house I was always curious about. If it weren't for the power lines I'd like the shot a lot more.

 

Anyone want some beat to shit 2nd gen headlights or taillights for free? tabs broken but they're free and Ive been using them for a while, just replaced them recently so I dont need them

 

dammnnn daniel

 

Finally got around to installing my bedcage this weekend. Still needs paint and etc.

 

Best antenna available for mobile use.

http://www.hamradio.com/detail.cfm?pid=H0-000559

 

Anyone interested in some 18" fox 5 way 3" bypasses? Jason said I should check here.

 

Price/condition?

 

Got my TC cam tab gussets today, is there any reason not to TIG them together instead of MIG?

 

I've personally done them either way, TIG is more time consuming. Comes down to how much time you want to spend welding, either way works.

 

Well my welding teacher and a couple of students offered to TIG it for me, and I still have to pull the drivers side suspension apart, so I'm tempted to drop the parts and instructions off with the teacher and tell him if he wants to he can have at it and if not he can pass it off to one of the students he trusts.

 

Just melt the metal

 

What welder are you using?

 

that thing was clean but it needed 37s real bad

 

They're 18" 3" 5 ways with a 1 1/8 shaft, and bypass on comp and rebound on one tube and comp on 2, and rebound on 2. They're used, they came off a desert truck, slight dent in one of the reservoir tubes and they're slightly different bodies. Can swap the bottom black eye with a blue one and a rubber bump. 1500$ for both or would trade for a set of 14" 2.0 coilovers and air bumps.@jberry813

 

It's a Miller welder. It's the one that can run as 120 or 240. Don't remember the series of welder though.