32" LED Light Bar Mounts - Stealth and Flush for 3rd Gens

ok, I don't know where the 12 volt side of the high beams is. Can you give some detail?

 

Ok so you tapped it right at the light? I was thinking you tapped it at the dash. You've had no problems with this? I was advised not to tap into factory harnesses that it would throw the system off.

 

Never had any issues this is just a 12violt signal for the relay all it does is trigger the relay
To turn on the wiring harness to the light

 

got it thanks!

 

might want to rewire that. wire taps are the bane of automotive wiring.

 

suggestions?

 

Sorry I can't help with the wiring guys, I am a welder... haha

In other news, I just so happened to miscount and I have one extra Stealth mount!! So if anyone wants it please shoot me a PM!!!!

 

Used them for years 0 issues to each his own as a trigger works great put shrink tape on it shortly after install so I'm not at all concerned thanks for your input though

 

cut the wire and either solder everything together and heat shrink or use sealed butt connectors.

 

I'm just speaking from experience. I pull them off on a weekly basis for wiring damage. Trailer wiring and remote starts are the biggest culprit.

 

the wire is still cut. will still need to address the wire if you remove the tap. good spot for moisture to get in and corrode the wire

 

Anyone got the link for the wireless remote so you don't have to run wires thru the firewall

 

Running through the firewall is very easy. There is a big ass grommet on driver side.

 

I saw that but I'm the guy that tap into the oem fog light wires to install my KC lights lolsee

 

http://www.roughcountry.com/toyota-tacoma-30in-led-bumper-kit-70621.html

 

I saw the RC kit but Chris's brackets look 10x nicer and more well built than the RC kit. Nit to mention he uses three bolts to secure the bracket vs two with the RC.

 

Finally got it installed!! Thanks again for setting this up bud!

 

which light is this and where did you order it at? Do you have a link? What mounting hardware did you use?

 

The light is the cali-raised 3D. I ordered the package with the brackets and hardware from @MojaveMadman

 

What kind of deal did you get on this? Caliraised has the 3D bar and brackets for $259
How difficult was the bracket install and where did they mount to on the truck?