What Have You Done To Your 2nd Gen Tacoma Today?

Ya that bubble popped up when I test fit it. Hit it with the heat gun 2 more times to double check it after that and it tightened right up. Its not hard just time consuming and takes a steady hand thats it. Plus its no risk... Dont like it? peel it right off

 

do i need to pop off the whole door panels to get the window/locks control plastic frame off? i'm not against having to do it, but would prefer not to if i can avoid it.

 

Nope, those puppies pop right off. I covered a thin flat head with a shirt and pulled up from the middle and the front

 

Do you have pic installed?

 

Ken Towery's in Mt Washington Ky. The front end tech who did my alignment has a couple modded Jeeps and is savvy on 4wds. Good place to do business

 

Sounds like strong plastidip to me lmao

 

Both you guys need to pay attention to your manuals, and quit listening to uninformed salespeople/service writers!
Go get your oil changed!

 

Whats the price on this?

 

Made official sticker design for fb group page. Join us

 

IIRC, the all weather flooring was 300-400. Someone mentioned it in another thread but don't remember if it was access or double cab.

 

Just run her over to the manual car wash and lay the pressure washer to it. It'll peel right off.

 

At 90kmhr & the guy didn't give me enough time to react. Main reason I have my 2015 tacoma. Still waiting on my settlement to even go to court.

 

I already had the old one, but bought this one in case there were any changes. They changed the lighting on the pictures. That's it as far as I can tell. they're all the same pictures, just edited for better lighting. The rest of the book seems to be identical word for word. I guess I have a truck copy and a home copy.

It's funny where they discuss auto LSD - they confuse it with the locking diff feature on the TRD OR.

 

I'm buying her in a little under two hours

 

Installed my Ram Mount thanks to the DIY on this forum. It is by far my favorite mod to date since I spend nearly 30 hours a week in my truck driving from jobsite to jobsite.

 

Installed new TRD polished aluminum oil filler cap and radiator cap courtesy of Toyota of Dallas and my BFF, the Fed Ex delivery guy.

 

Man that looks terrible. Hope everyone was ok!

 

purchased a new 7-pin trailer harness adapter since i smashed the tar out of mine. most boring $170 i've put into this truck so far.

http://www.ebay.com/itm/221750967583

 

Which one did you go with?

 

Painted engine cover version 2.0. Used duplicolor wheel paint since I already had it, silver with graphite in the centre section.