What Have You Done To Your 3rd Gen Today?

No cause my local shop didn't have it and the last time I talked to "dipyourcar" where they have all different products, they said they can't send cans over air so I would have to order bulk and have it boated over. I don't think I'm gonna use a whole box of glossifier

 

Why are you trying to be a ford?

 

Did you order/install the fairing edge trim?

 

Did you order/install the fairing edge trim?

 

I just went with who had the fastest turnaround for availability with the lowest total cost including shipping. There are so many vendors on here that make nice sliders that im sure you will find one you like that is relatively low weight. If weight is your primary concern then I recommend weld-on sliders since i believe they are much lighter. For me weight isn't an issue yet...but that may change once I get my RTT on and load up the gear. I may have to beef up my suspension next.

 

Gotta do what you gotta do to get the Manual. I drove three hours to get mine.

Congrats

 

Are you running with wheel spacer? Your stance looks a good bit nicer than normal OR. Maybe it's just the tires.

 

Installed OME 2883's and Nitrocharger Sport shocks. Trim packer on the driver side. No lift gains on my 2016 Doublecab 4x4 Short Bed TRD Offroad. Already ordered 2884 springs. Looking to level the truck off.

 

Not actually mounted yet, waiting on my PE switchblade. Mobtown bed bars for my rtt.

 

Did you get the black leather clazzios? I'm thinking about taking that route as well. Let me know where you got them, and the price (if you don't mind, of course).

 

I order my clazzio black leather seat covers 3 weeks ago . They are out of stock. So be prepared. Call them for a better deal than online pricing.

 

The auto parts store is where I found mine. Came in strips probably 1/2 inch wide. Used an exacto knife to trim to fit the Tacoma emblem.

 

I'm looking for sliders that sit as close to the door as possible. Is this about as close as they come or does someone make something that fits closer?

 

Nice, did that give you an 1'' lift going to that size tires?

 

Where'd you get them from? How much?

 

It honestly depends on the manufacturer. You could get the sliders even closer to the doors but then they would have to be shorter to not hit the fender flares, fenders, or bed sides. Also, when you flex the chassis the body doesn't flex the same and in the event that you use the sliders as they are intended (sliding on/off rocks and/or dropping down onto a rock) they could theoretically flex up into the body causing damage as well.
There's a fine line between clearance, looks, and function.

I ran a few different sets of sliders back in the day on my FJ and I know what works for me functionally and what I like as far as looks go. I chose to run the hybrid DeMello sliders because they look awesome and provide the protection I need.

 

Autocustoms.com. I spoke with a live chat rep and was able to get these for $365 shipped

 

The Katzkins replace the stock cloth upholstery

 

Yep, waiting on the all black leather covers. When I ordered from their website, the coupon code 'love' still worked from Valentines Day so I was able to get them for $430. If you call them you might be able to get them even cheaper with a possible TW discount. For me, I was satisfied with that price.

 

Bike fits, 29er with a 19 inch frame.

Plenty of clearance when fully extended, installed three across the top of the toolbox. Lid is almost an inch thick and I used 1 inch washers and nylon nuts for stability and security. You can't remove the screws without opening the lid.