What Have You Done To Your 3rd Gen Today?

Good point! Did you have to drill a new hole or use an existing one?

 

Used holes that were there already just made a plate that covered 4 of the holes drilled the plate and welded off the plate easy to remove seems solid enough

 

Bearing did the job re packed it and welded plate on top then built off that

 

Salvaged an old back pack pocket and velcro in makes storage a little more organized and free. Also used back pack straps and buckles to make a bed side axe mount worked great no pics tho .

 

Nice job man, thanks for the pics and inspiration!

 

Next mod

Tires

 

Highly recommend the JDM 800 lumen LED reverse lights

$23 at

GBAuto GBAuto-w5dxw T10 car led

http://www.amazon.com/dp/B00K3GBRQ2

 

For those that have switched their rears entirely over to LEDs

I understand it takes two 7443 per side? And on the turns you need to install a resistor

Is this correct and any brand recommendation is appreciated

 

I've got WeatherTechs and they're not very flexible.

 

Thank you!

 

Love the km2 had to go with the 265/70r 17 they are a little noisy when you get up around 70

 

Is your truck lifted or is that all stock with those wheels and tires?

 

I have to know did you make it out this unassisted?

 

Curious if anyone else on here has noticed that the windshield seems to be very "weak"? 2 small spider cracks in under a week and they weren't from large rocks or anything. Just normal road crap. Had an old 4Runner I drove for 10 years - not one crack. It could just be bad luck.?

 

Yep, already had to replace my windshield once and I already have a chip on the new one. I'm not sure if it's the angle of the windshield or the thickness but it does seem to catch damage easily.

 

Amazon says "does not fit" for a 2016 Toyota Tacoma!

 

Well I had to chop down a tree and strap about 2 foot chunks to the tires and it hopped me outta there lol. YouTube special

 

You had to up the cuteness factor didn't you... LOL

 

Rad Company

 

VLEDs. There is a thread in 3rd gen showing install and improvement. They are a little more $. But I would say well worth it. Turns you do need the resistor or you get hyper flash. The install took about 30 minutes. Everything you need. Get the heat shrink wrap for the connections and heat resistance mounting double stick tape for the resistors from them if you buy. Quality equipment my opinion.