What Have You Done To Your 3rd Gen Today?

ugh, thats my wifes shit...

 

Looks great!

 

Took the lipstick off lol

 

Got my wheels and Tires put on this morning! Love the way it came out. Stock suspension 265/70/17C fyi- no rub lol

 

Hope you like the product man. It's looks great! Something I recommend is using this edging trimmer too. I did it on 50" curved and helped a ton.

 

Derp'd the grille and added FX Pro wheels with 265/70/17 K02s

 

Looks good.

 

u dont happen to live in bullhead AZ do u?

 

@odinsbro Close, but no. I'm in the Phx Valley

 

I've done some things too that later you ask yourself what the hell was I thinking, like in the mid 80's when everyone was putting pink graphics on their vehicles, I joined the fray and put pink stripes on the sides of my Mazda B2200 truck........my oh my.

 

I love in the inferno Tacomas that their radio trim is painted to match... so I thought I would get my interior looking the same...

 

W A N T !

 

Not 2 hours ago I asked my wife "how do you think the bezel would look blue ." You have great timing!

 

Looks great, when my truck arrives I would like to do a similar set up (Inferno rig). Just not sure if I want to do KO2s or Toyo ATIIs.

 

How hard is it to pop those off?

 

Post 10644, 1 page back I just did ATII's Traded stock rubber for $100 per tire. Was looking at K02's as well but the TOYO's were a couple hundred cheaper. Less aggressive sidewall but the tread is more aggressive I think.

 

Nice.... Which wheels are those and where did you get them at?

 

Thanks for the likes!! It was a lot easier than I expected to do this. Start from the right most of the trim and just pull it with your hands. Then follow it along to the left (towards the steering wheel) Once that part is off you can remove the left side trim. Lower and pull out your steering wheel to it's furthest position and then lower both stocks (turn signals and wipers) this will give you enough room once you pull the left trim to wiggle it up and out.

The painted trim then is secured to the main housing with about 10 total tiny screws and a few clips that you can pry with your finger or a flat head if needed. It all came off and undone within 5-10 minutes. Sprayed it with 5 coats and let it dry over night and then reassembled this morning.

 

Thanks Jake, I love the bar! I saw that other people had used that edge trimming with good results and was going to give it a try. Thanks for the great service!

 

@fshams TRD Pro wheels, got them from Olathe Toyota, there is a thread on them.