SMKYTXN's Build

1" body lift complete along with upgraded poly body mounts.

 

what one did you use ? I thought about making my own with HDPP and proper grade bolts

 

I used the 4crawler kit.

 

Im just going to go find a cut off sheet of 1 inch and use a whole saw on the drip press to get dead centre cuts
How many blocks are there, 8 right ? Replace all the bolts with grade 8 bolts and locking nuts

 

12

 

i stand corrected. what is the diameter of the blocks they use ? 2-3 inch ?

 

the core support and rear bed mount are a little smaller and I think the main cab and bed mounts are 3"

 

Correct, 6 for the cab and 6 for the bed. I didn't raise my flatbed though, no point.

The core support was about 2", maybe 2-1/4", and the main pucks were 3".

The flatbed made life easy for me. I could reach both sides of the rear cab bolt with ease. The polyperformance bushings are a lot nicer design in terms of serviceability. The bushing is two pieces so you only have to raise the cab about a half inch to get everything out.

 

Fluorescent hot pink is a good color for the ifs skid, right?

 

Only if it has your logo plastered across it as well

 

I can make that happen.

 

@geekhouse23

 

I couldn't find a blue spray paint close enough to my logo so I went with bright fluorescent pink.

 

GM color medium metallic Maui blue should be very close to your logo. Was the color of my first car, the 88 Camaro.

 

Thanks for the heads up.

 

Did ups drop something cool off today?

 

please say there's a clocking ring as well.

 

Clocking ring and transmission adapter are there, just didn't get pictures of all the bits.