Colorado B.S. Thread

I'm still not to keen on getting rid of my current setups to run HAM. @Gramps I would have to get Crissy licensed also as CB is our primary communication when is different cars. I hate the rules that come along with communications on those bands.

 

Ohhhh makes sense. Sounds like a good license to have!

 

Why not both?

 

Only if everyone in your group makes the commitment to get the license. Otherwise, in the 4wd community it is just elitist hardware. I have not made the jump yet as CB is what almost all want to spend the money on 4wheeling. A truck mount 2m setup is going to run around $500 and most will not pony up the cash. A handheld can be cheaper but suffers range issues inside the cab of a vehicle.

 

Brian my Kenwood 2m setup is less than 350

 

Yeah I guess it is kind of pointless when not everyone has a HAM in the group. That's quite a bit to spend on a radio setup.

 

@TacoVio yup Brian @thefatkid is the guy that help me with the advise on getting my CB working right. With a ground wire like this. I'm using two.

 

I have no issues spending that kind of money on a radio setup. My issue comes from the less then 5% of the people that I 4wheel with even express interest in getting the license because most CB is sub 90$ combined. I'd rather run 2m and lose the skip and riff raff.

I would also have to ditch my current radios, they are not quite type accepted.

 

Looks like a good unit, where are you going to mount it?

 

How well does yours work being mounted to your front bumper? That's where I would want to put my antenna

 

Actually on second look
Kenwood 281. $125
Nmo antenna. $50
Coax cable $50
Mount $30.
Had the majority of the electical stuff to do it myself.

I agree with not enough of my group typically has it, but it was that way until the first guys got cb too. Someone has to be first

 

For all of you guys with the cobra 75, if you could go back would you buy it again? Is it good enough, or would you buy a full-size unit?

 

uniden CB, i still wanna get it worked on, bump up the watts a bit

 

Does that one do repeater offsets and tones?

edit: no detachable face, doh!

 

It uses tones to access repeaters in range and has a low 5 watt and high 65 watt setting to extend that range

 

everyone i run with, we use vhf. most of us run the icom f5021. its a much cleaner signal compared to cb, however with the right equipment cb will reach a lot farther. vhf is nice because you arent stuck with the same channels as everyone else

 

Bump

 

Still TBD. Probably in the center console if it fits, or in the cubby below the radio and cabin controls.

 

Can I get something like that at lowes or where do you suggest? Also did you ground it directly from under your antenna or on the hood mounts to fender/frame etc.?

 

Any auto parts store will carry them