What Have You Done To Your 2nd Gen Tacoma Today?

I liked your post about liking posts!

 

blacked out all my emblems and rear bumper grill next it's about all i can do rt now only using 1 arm. i've gotta figure out how to post pics here

 

They're not hard to install. Use a floor jack with a longer 2x4 or 4x4 block then balance the block and sliders on top. Use the jack to hold the sliders next to frame and lined up with the holes. Get a few bolts in and you could remove the jack

 

Take those built in swr with a grain a salt.. dedacated ones are better

 

What did the powder coating run you? I'm thinking of coating my bumper.

 

I paid $160 including the all the washers and welded nut pieces. Just the sliders would have been $135.

 

Took the Plasti-Dip plunge... Pics look weird, but it's black!!

 

That was the first thing I did to truck. Did front emblem as well.

 

Just did tailgate emblems tonight...I'll get the doors next day off! Grill is switched out to @HomerTaco ghost raptor mesh grill!!

 

I have a TW crush on @HomerTaco ! Don't judge me! His work is WINNING!!

 

Very nice job!

 

You can't tell much from this pic....but now I wanna do a horn relocate and paint the other parts black!!

 

Bronze emblems would look nice. Just saying.

 

You may be correct! I'm telling you! I was going for the blacked out....but may have to try something else.....bronze plasti dip??

 

Good idea - horn relo takes no time at all. Painting the rad is pretty quick too. It makes a big difference - so much cleaner looking afterwards.

 

Diff breather mod and painted front emblem

 

Write up??

 

I just did the relocation, here's the before and after pic:



You could even paint the silver parts/tube behind the grill black too so it blends in...

 

It's so simple it doesn't need a write up.
Just separate the horn wires from the temp sensor wires (if you have them) then either bolt the horns back on below the grill opening or behind the fuse box on the drivers side under the hood.