What Have You Done To Your 2nd Gen Tacoma Today?

Easy hit upload fine then hit find your gallery under under documents. @ least that's how I do it.

 

This is a great goal, I'm using my phone 95% of the time on here.

Go to the bottom of the page to 'upload file'

Thats how I do it atleast

 

How does it sound I've been looking at these

 

cool i'll try and sit down tomorrow and figure it out

 

What's the thread name?

 

Just click my sig.

 

Bought some quick fist mounts for my shovel... Problem is tonneau gets in the way of shovel if I mount at bed rails.

Anyone drill into to bedside and how to secure from the other side?? I could probably get one from the side cubby, but not sure how to reach the other. Ideas??

 

What kind of prep work did you do for the por15?

 

Glossifier will make it shiny as well.
Check out dipyourcar.com

 

I'm pretty impressed with it overall it doesn't "slap" by any means, but it does round out the system really well and sounds awesome. I can even feel it in my chest a little if I turn it up

 

Not much, but i did think about stuff i want to do to it about 28 times.

 

28000.00

 

Well it was hard to climb under there and clean everything so I took the spare tire off and could sit in there which was really nice..

For prep I started with a wire brush and cleaned all the flaking paint and rust off (a drill with wire brush would've been handy) then took some brake cleaner and a few rags and wiped all the oil / grease / dirt off (degreaser / water would have worked too) you literally paint the por15 right over the rust and it sticks on so nicely, it's amazing stuff and not much prep is required at all

 

Quickfist install & test fit! Promptly moved the shovel's middle Quickfist to just on the other side of the sliding window. I can reach it standing next to the truck without stretching.

If anyone is curious:
These slot nuts

$20 Te-Co 41406T Black Oxide 1018 Steel Tapped Through T-Slot Nut, 3/8"-16 TPI, 5/8" Height x 7/8" Width x 9/16" Table Slot (Pack of 5)

http://www.amazon.com/T-Slot-Finish...&redirect=true&ref_=oh_aui_detailpage_o00_s01 fit the rails PERFECTLY

But the hole in the Quickfist's is only 1/4" and the nut is tapped for 3/8"-16 coarse threaded bolts. So I had to run a drill bit through the quick fists while they were wrapped up in a vice. They fit and feel perfect.

 

Made my own iPhone holder.



You can see more details on my build thread here

 

Added some patches to my overhead, most were given to me by my grandsons.

 

Tap "upload a file" then "choose file" then pick take photo, or photo library.

This is for iPhone. But I bet it is about the same for android

 

A sawzall would work well. You might need some touch up paint afterwards

 

Nice! I'm surprised how well the dip matched.

 

Make some drop down brackets.