NJ B.S. Thread

@EcoBill want to meet up later today

 

Hunter where is a decent spot to wheel at by you

 

There really isn't anything decent for trucks... Only ATVs.... Trails aren't wide enough

 

Alright guys... Back spacing on wheels... What back spacing do you recomend for me to run 285s on my truck when I lift it? Ill be getting treadwright guard dogs... I can go with a 16 or a 17 since Ill have to get new wheels... Or I would get 255s... But id still need new wheels since those are for a 16 inch wheel

 

What you guys gonna be doin?

 

You can get 255s for 16s or 17s

 

I wanna go bruh

 

It's a neat little spot but can really only spend an hour or two there. Also most second gen's will get a lot more scratched than me, the one tight section I go on is quad trails ha

 

Who dis? Spotted in Pa this morning, jersey plates.

 

Looks like some db.

 

Where's that at? Sick set up

 

Little jelly no invite.

 

I was invited by someone else. Kinda like a test run didn't really know what to expect

 

So many achevment patches this weekend

 

Pennsylvania

Wasn't for the masses

 

So today I went to do brake pads on the truck... Had a funny noise so I thought it was the brakes just rubbing the rotor... Turns out I had a fucked up piston. Time crunch didn't allow me to take it apart and rebuild it as Kevin had suggested to me as well as my roommate had said there is a rebuild kit but either of us had no time to do this... So I had to get a new passenger side caliper. Cost me 70 dollars for the caliper and 35 for the pads. Annoyed I had a caliper go out at 58k but happy it was just that and it didn't stick and warp my rotor or some crazy shit... I would have bought both sides but they only had one side in stock and luckily it doesn't pull to the right when braking so its all good

 

I had a passenger side caliper with a seized piston. Changed out the calipers on both sides with reman. Ones from rock auto.

 

Hey so does anyone know of somewhere that has mesh grills for under $200 in stock? I have a backorder with two companies and I see @HomerTaco has enough orders to deal with..otherwise I'll be doing it myself I suppose

 

I sell just mesh too...