What have you done to your Tacoma today? 1st Gen Edition

That would be my guess. I'm running the same size tires with 1st-Gen TRD rims and no rubbing.
I put them on before I lifted it about 1.5". No rubbing before or after.

 

That's good to hear. Do you have a write up on it? I have a shop ready to do it on Wednesday, but if it's that easy I can possibly do it myself.

 

Alignment?

 

They were just aligned so don't think that is it.

Probably the rim choice.
Waiting for the SCS rims to come!

 

I'm pretty sure 2ND gen wheels are 5.5" of backspacing. This puts the tire almost a full inch closer to the frame over the stock wheels.

 

Don't have a write up, but it literally takes 5 min and you can get to it from underneath the truck, pick one up from O'Reilly's cost u like $20-$30

 

Here's what I'm working with, also what's the distance from the rear of the console to the rear seat deck?

 

Look at this link: Pulley noise the little pulley to the right in the pic is your idler pulley, it put tension on ur ac compressor belt

 

the fit won't be perfect with a center console with the bench seat shift boot surround. trust me, it's what I have right now, as I wanted the cup holders... but it's not a big deal since I'm not OCD... then again, at the moment my center console is grey... so take it for what it's worth

 

Thanks! That's exactly what I was wondering...no worries guess I will try and find the front console as well.....is there a good amount of distance from the rear of the console to the back seat deck (not sure what to call it, but the platform where the rear seats fold down)? And thanks for the help!!!!

 

Went wheeling

 

Well....this is happening. Going from 10.5 BFG KO's to 12.5 BFG KM2's

 

let me take a pic... not sure what you're asking... but give me 5

 

Put in the ECGS bushing in my driver side axle tube and replaced both broken CVs. 4wd is back! Found a nice gear puller and parts from old coilovers to pull it out. Used the CV shaft as my bearing driver.

 

Looks good ! Where did you get ? Thanks.

 

Thanks bro.....this is why I ask, making sure I will have enough clearance

 

here ya go

 

FYI for reference... the seats are in the furthest back position. and the little cubby is open on the back side because that's where I moved the CB box for my WX75

 

Yeah, the console will matche up perfectly to those screws on eithe side of the shifter trim.

I don't know the measurement you're requesting but the holes in the console (for 10 mm bolts) will line up perfectly with the threaded holes in your tranny hump.

 

Huge Mahalo'z !!!!! Fit looks good to me!!!!!