Uneven bed after lift help.

Do the shackles move freely ?

Is the centre pin positively seated in the axle ?

 

This is the drivers side shackle

 

Don't know about the center pin in the axle. Maybe it's not

 

When I installed the leaf I broke the bolt that came with the kit and bought a replacement at lowes. Possibly I didn't seat it properly in the axle.

 

Maybe some pics of leafpacks at axle pass and drivers side

 

Check to see if any gap between leaf and axle.

 

If your centering pin isn't properly aligned you should definitely notice. Does one wheel seem further forward than the other?

 

Passenger side

 

It just wants to be like its big brother...stationary...

 

Drivers side

 

No it doesn't seem farther forward.

 

it means you're almost out of gas.

 

Lol

 

Just an idea is the AAL equal length from the pin hole, I have seen some leafs longer on one side then another. If so the orientation maybe different left to right. Again just an idea.

 

Mine is just the opposite. My left rear is lower than my right rear. I have a 1.5" AAL.

 

I don't know if the shackle moves freely. I guess the best way to test it would be to jack the truck up and down and see if it moves. Or, maybe just have someone jump up and down in the bed. What do you think? I'm assuming it will barely move.

 

@skyline88 well you weren't kidding.. ive owned 3 tacos and they always came with the infamous taco lean.. interesting..

@toppdawg any luck with your problem, keep us posted,

 

OP, you may have to let the leafs break in. When I installed my rear end, I got sever taco lean, ~1" lower on drivers side and it got worse as leafs fully broke in ~1.25". Had to install a 3/4" spacer in front drivers to level, sits 1/8" lower on drivers side still but no longer noticeable. Of course that was for ~4" lift

Did the aal you install have different leafs for drivers/pass? could be spring rates to compensate for taco lean, hence sitting higher on drivers side? Let them break in for a couple months and report back. Its nothing to worry about. Just displeasing to the eye.
Possible alignment issues?