What have you done to your Tacoma today? 1st Gen Edition

Just happen to see this and thought it looked pretty sweet... along with a few other trucks like a tundra and 4runner,

Got my brakes today hope to get them on this weekend...

 

Headed to moab perhaps

 

Cut my fenders. Should clear fine now.

 

Got a yellow top in, ill see how it does...







Also, started a groupbuy on some uniball uppers....


https://www.tacomaworld.com/threads...-1st-and-2nd-gen-tacoma.435023/#post-12574764

 

A tundra in the convoy also I just know Cali license plates headed south on i15 through slc Utah so it's possible.pretty sweet setup and alot of time and money invested for sure .loved the dual swing out bumper

 

Looks great man!

 

Got a few cm snow tonight and pretended to be in a drift car.

 

Pretty sure that's Billy from Bruteforce Fab. His rig is ridiculous

 

Installed my new WRX buckets today, courtesy of @Tacofire98. Soooooooo much better than the shitty stock buckets!

Craptastic picture, but y'all get the idea.

 

Have a website by chance?

 

How hard to install as I loved my old etc seats I had I had in my Scooby..

 

How was it putting it in? I assume it didn't align perfectly and bolt right in.

 

I had to do some fab work. The factory brackets were close just needed a little modding. It's just a bolt in set up now.

 

Yep, some measuring and welding involved for adapting the brackets to the Taco hole pattern, but since Jake had done that previously, it was about a 15 minute job for me.

If you have welding skills, some steel sheet stock pieces and seats from a salvage yard, it's totally worth it. Best mod so far.

Thanks again, Jake!

 

https://www.tacomaworld.com/members/bruteforce-fab.184050/

Here is his profile here.

http://www.bruteforcefab.com/

And his website here. But honestly it's kinda old. I'd go into the threads to find stuff. Or his Instagram if you have that

 

Love these. Getting 35s in a couple weeks. Looks good.

 

Factory spare tire carrier under bed. Largest size tire it will hold? Anyone ever modify it to hold a bigger tire? Might wanna trim off the curved pieces to see how/fabricate/what it would take to fit a larger tire under there, if possible between leafs and rails. Comments concerns suggestions....

 

Curious about this as well. Although the 33 I have in mine would make the high clearance bumper I have pointless

 

Thats why god made 'pizza cutter' tires, so a full-diameter spare can fit under there without hurting the departure angle.