Looking for advice for RE Badging my Tacoma. 1st post.

Hello. This is my first post on this great website. I just bought a 2007 Tacoma DBL Cab TRD Sport. I recently debadged my vehicle and painted them flat black. I bought some scotch double sided tape to re assemble them. The tape was very difficult to cut and almost impossible to cut the center of the "o" and "c" in Tacoma.
I was wondering what is the best stuff to use and how to properly use it. Thank you in advance for your help and support. If you have any pictures and or videos that would be awesome.

Thanks,
Matthew

 

I am thinking of painting mine and was wondering the same thing?

 

At Home Depot there is the 3M or Scotch adhesive that is the same as the original grey adhesive. It is a soft, pliable, clay like feeling that comes in a roll. Apply the adhesive to the badge first, then use a razor or exacto knife to trace and trim the edge of the badge. It cuts like clay. It will give you a great finish.

I used this stuff to hang my fire extinguisher bracket in the bed. It sticks.


http://www.homedepot.com/h_d1/N-5yc...splay?langId=-1&storeId=10051&catalogId=10053

http://www.xacto.com/p_cuttingtools_knives.asp

http://solutions.3m.com/wps/portal/...E3E02LECIE20S0S0_nid=4K1SPQCWB5beV0141B40KNgl

 

Thank you for your help. That 3m stuff looks great. I was wondering where I could buy that. I had bought the scotch brand And noticed it is extremely hard to cut. Any tips/advice?

 

I just cut little pieces and went all around the letters.. little rectangles all around the backside bam! all done

 

Its tedious. Use a razor knife. Take your time. Your fingers will be sore. Its worth it.

 

Welcome to TW! The 3M stuff is great. If I black mine out I am going to use some MIL grade stuff. Probably B1/2

 

Thank you for all your replies! I will try the 3m stuff tommrow and post some pics. Thank again