What Have You Done To Your 3rd Gen Today?

Just something to protect the fabric on the seats, hopefully since its 108 degrees here it will iron out and lay flatter over time

 

Nothing else....set @ 1.75

 

He was jealous of your Taco

 

wow

any rubbing on the 275's?

Think Ive made up my mind Bilstein it is.

 

Thanks it seems to be the best value unless you want to spend twice to three times the $$ for not much more.

 

Husky X-act contours front/back.
Interior cleaning/protecting - 303 protectant and fabric guard all around... immediately spilled water in it afterwards (anniversary flowers)... beaded up and ran off the seat.

 

No rubbing yet...I did remove the mud flaps too.

 

Maybe a novice question but when using the bar do you rub in a circular patter or back and forth?

 

I did the tape measure mod for my scanguage 2 today. Still need to tuck in the cable behind that pillar under the dash. Is it easy to open/pull that part. Got to be careful to tuck wire in right channel not to interfere with airbag functionality.

 

5160 ext travel shocks to match the 6112 i did a month ago. Because reservoirs look cool.

 

Me too I little diversity never hurts....

 

Put a 2.25 readylift level, fox shocks, 265/70/18 Nitto G2 grapplers and 18X9 Fuel Vapors today

 

Nice! I'm looking to do the same. How much to tints usually set you back? Also, is that within the legal limit in your state? I know NC is pretty strict on window tinting, but a good tint is a good tint!

 

NC is tough on tinting

 

How difficult was that? Any tips? Do you look at a how to anywhere?

 

Just back and forth, no circles when using the clay bar.

 

What does clay bar do ....

 

Cleans hardened debris that has embedded into coating, like exhaust debris and the like.


I think

 

Finally got my ray10's and ko2's put on today