What Have You Done To Your 2nd Gen Tacoma Today?

Working on my aux fuse box mtg plate today...

 

i found the imogees hahahahaha

 

Yota mafia I believe does it. I saw it on Instagram and ordered it. I have it on my truck and it looks awesome and has held up very well.

 

Or did you?...

 

ahhh that's a good 1 shaky shaky

 

Sound clip?

 

Does the brake controller get in the way when getting in and out? I need to relocate mine.

 

not at all, plenty of room. i had it sitting on the right side before attached by the shifter but that got annoying quick when i tried to use the manual lever on the controller

 

Nice, join our group

 

I put mine in the small change tray area to the immediate right of the steering wheel/ignition

 

Found a sheet of rubber to redo my fender liners. Time to make some templates tomorrow and see what happens

 

Did you have to take the wheel off to do this? Is there a write up that you're aware of? Thanks!

 

https://www.tacomaworld.com/threads/upgraded-inner-fender-splash-shields-update-2nd-run.391443/

Theres some info in that thread with a few pics.

I plan on DIY'ing mine based on the info in that thread. Id imagine I could probably get it done without removing the wheels since the trucks lifted and there seems to be a good bit of room to work. I may jack the front end up though to make a little more room to work. I plan on starting this project tommorow as long as I can find enough panel fasteners at the hardware store

 

Like this?

 

What group is that?

 

nice i did the same. I see you went ahead a sprayed the black plastic on the top of the bumper too. I actually tried to tape that off as well. Did you have any trouble peeling/tearing it away?

 

all the black was taped off. i had a small problem along the edge of the black in the corner bend but i fixed it. i only seem to have these problems when i use white with the glossifier but the glossifier is worth it if you get dirt on it you can use a little detail spray and it wipes off without it i think stuff would stain the white

 

Yeah i had the same issue on the corner bend, but i was able to touch it up. I actually didn't use any glossifier. Do you think i could clean it up and still apply it now, or too late....?

 

i would think if it were clean it shouldn't be a problem. what's the worst that can happen it doesn't work the strip .it and redo it cost you maybe $15 and a couple hours time playing with your truck. i know that's not prefferable but not so bad either