Official 2016+ with Fox lift

Thanks man. just bought a spanner wrench to make things easier.

 

looks great!!

 

I am running the Fox 2.5 extended length in the the front, and I am only seeing about 1" of lift ( 22" hub to fender). The Fox rep says they are set for 2" of lift from the factory, but that may be for a 2nd Gen. I have 2" of tread showing. I tried to adjust them yesterday to get another 1"- jacked up the truck to take the weight of the springs , loosened the nut and used spanner wrench. That ring is Fing tight, I could not get it to move. Anyone else having issues making adjustments on the 2.5 coilovers?

 

Looks like 2" of threads and you're going to add more?

 

read through my post.. Should answer those questions https://www.tacomaworld.com/threads/fox-2-5-missing-locking-ring.427114/

 

Ya, i tried the WD-40 route, maybe i need to let it soak in more...

 

Mine were super tough to turn out of the box. Basically soaked them in gun lube(CLP), put the spanner wrench on and hit it with a rubber mallet.

 

I was never able to adjust them on the truck. Ive removed them 3 times already to make adjustments. the reservoir hose also seem to be in the way when doing it on truck.

 

Do you have 16" or 17" methods?

 

It does matter.

FYI:
The springs should be set to the necessary load (based on weight and necessary stiffness). Height can be set here. The shock's dampening should be set specifically for the spring rates.

 

Hmm. Its been about 7 months since the OP did this. How bout an update?

 

Curious as well as I am on the fence between Fox and Icon....

Anyone know if there is another Fox thread I am missing like the Icon one?

 

mines on order.
full 2.5 fox extended travel front remote resi
rear shocks and dakar leafs.
Total chaos UCA
etc

the rear shocks are on back order so hopefully its here by spring

 

Does anyone know if I am going to have an issue tomorrow when I install my rear Fox 2.0 RR?

If you look at the picture you'll see the braided line comes straight off the shock instead of bending downward 90 degrees.

 

Nope, no problem. Those braided hose lines are pretty difficult to kink. FOX designed them like this vs. using the 90 because these shocks are used for other platforms even though they are specified for Tacoma.

 

Awesome! Thank you

 

So new coil overs and shocks are the only thing y’all used to lift truck or do y’all also have a suspension lift?

 

I need some Fox chit in my Taco's life!!

 

Coilovers/shocks/struts are part of a suspension lift.

 

So if you did that and a 3-1 lift kit would the 2”-4” UCAs be ok?