JDMCQ's Garage

?????? don't know that i've seen that one

 

You've been busy tonight Brandan...

congrats on the 12,000

 

http://www.tacomaworld.com/forum/2nd-gen-tacomas/46255-all-abs-satoshi.html

thanks

thank you

 

in 4 days i posted 420x

 

thats a helluva lot for me!

 

Thanks for the link.... wish he had some pics though If you do it, take lots of pics

 

that's alot of posts... don't know what I've done....

 

lol if i do it i will


he did a really good write up and i think i understand what needs to be done

 

thats really only 3 days of posting.... i had a few on the 28th that i included so it wouldnt look even worse

 

He did a good write up, but I like pics Just to be sure I'm doing it right

 

the pics would have been icing on the cake for sure

i think the thing that is stopping me the most is the fastening of the mesh to the grill. i don't know how well epoxy will do with the cold up here

 

We use it on airplanes that are exposed to cold temps and the stuff doesn't fall off You might want to check the package to see what temps to use it in.

 

lol good to know! now i really have no excuse to not do it. just need to find mesh and set aside some time

 

If I use that stuff, I won't need to wait until it warms up outside. You gonna go with the expensive grill craft mesh or the cheap hardware store mesh?

 

i found a metal fab shop that carries several different types of mesh. i'll likely grab some from there

 

the grillcraft stuff is too expensive

 

I found a fab shop as well... they only had one type that was available... but if I check again... maybe they will have different types. My only problem with them, is they close very shortly after I get off work..... doesn't leave much time to look and figure out what I want and have them cut....

X2 on the grillcraft

 

ya i would have to wait until a friday afternoon to get anything.

 

I don't get off until 4:30 and the shops close at 5... takes a few minutes to get there, so doesn't leave much time to do anything... Might have to leave early one day so I can get some

 

that would be a problem. i only work half days on fridays so it gives me a bit of time.

what type of mesh are you thinking of getting? i go back and forth between the small diamond mesh and the small perforated stuff