What Have You Done To Your 3rd Gen Today?

Got TRD wheels with Goodyear Wrangler ATs 265/70 17. Apparently I forgot to order black lug nuts... Old wheels going on my 03 T4R.

 

Those rims are BadA$$

 

There is the gromet or you can follow the main harness that enters the cab.

 

Thanks!

 

Redline hood struts?

 

Redline Tuning (redlinetuning.com)

 

Nope problem. I'll take some pics if I get a chance. Good luck

 

Here's the thread if you want to see more pics.

https://www.tacomaworld.com/threads...tacoma-hood-quicklift-system-released.426985/

 

Much appreciated. Did you by chance remove the center dash "switch plate?" I'm going to have to take mine out to run wires and a new switch. Also, what did you tap into to send power to the switch?

 

3D printed an adapter for the GoPro mount, for a cheap dash cam.

 

Here's the pics as promised. They are pretty damn bright. Wish I would have taken a pic before I swapped them out...

 

Pretty much done with build.
FN TRD Gloss dark gray wheels, Nitto Terra Grapplers G2 265/70/r17, stock suspension, OEM mud flaps from Amazon, OEM running boards from Amazon($299), GatorTrax retractable cover, LED strip lights each side of truck bed, BedRug, then went to Home Depot to buy some gray carpet to put over the BedRug since I get lots of sand from beach(easier to whip out that rug and shake out). Red Tacoma resin 3-D reflective decal on tailgate, dipped grille and badges, blue LEDs interior, window shades, SmittyBuilt step, black tail pipe tip, and window shades.

 

Truck look great man!! Well done!

 

Yes I left the overload in. I wanted the extra load capacity for hauling loads and trailers. Ended up 2" higher than stock. You have to cut off the front bracket on the overload because it is in the same place as the spring clamp of the icon aal. No big deal with a cut off wheel on a grinder. You will need the grinder anyway to get rid of the factory spring clamp on the factory leafs to install the icon aal.

 

Looks like this when the front bracket is cut off and aal installed.

 

Couldn't take the look of the chrome grille. Going to buy a new one soon hopefully, but for now I bought a can of bed liner spray and sprayed the grille. Have a little touching up to do but it looks way better than before.

 

Here's a few more pictures!
4:88 gears F/R ARB Lockers, and CBI Rear Bumper with Swing-out, coming soon!

 

Great looking rig. Black out the chrome grill ring and badges and you're set.

 

I used the plate to left of the steering wheel. They all pop out pretty easy with a plastic trim pry tool. I using a switch pro so I used a add a circuit to the injector fuse as an ignition sense source. You could probably tap into just about anything in the interior fuse panel for switch light power.

 

Thanks for all the help dude