What Have You Done To Your 3rd Gen Today?

It's the oem bed mat.

 

I replaced the TRD Sport bedside decal with this one. More subdued and like it much more.

 

I added LED fog lights from Diode Dynamics. I did a few comparison pictures with the LED installed on the right side of the Tacoma. It took less than 10 minutes to switch out both bulbs. I'm a fan of 5000K+ lights.

 

Doggie Bench / Lockable Bike rack / LED lights throughout entire truck inside and out.

 

why do you need that much lift in a 2 wheel drive?

 

Just wanted bigger tires with my new 17" ray10's

 

Why do you need bigger tires with a 2WD?





-snickering while driving my 2WD-

 

sorry, just wanted a better stance and look! I know I'm a looser with a 2wd, my bad! snicker snicker

 

Did you gather hub to fender measurements before and after? What about slapin some LR UCAs on there and calling it a day?

 

Didn't think of that but, may try! I measured the rear only and was 1 1/2" higher in rear!

 

Service #1 apparently they are covered under my lease so what the heck! Second diagonal rotation for my duratracs, they seem to like constant rotations.

Sold the stock Goodyears today to a 1st gen Tundra owner. Good day!

 

I'm by no means an expert on this stuff but guessing any issues your having is too much lift with the stock UCAs. I'm at almost 2.75" over stock in the front and everythings gravy. I'm also running uniball UCAs and a diff drop.

 

Today, a picture, next to psychedelic wall, was taken.

 

Installing a Bestop Supertop on mine.







Have to wait for the top and panels to heat up in the sun tomorrow to get it to fit right.

 

Check out some of the guys with the pro comp 3/1 kit. theirs looks just as high. as for the alignment, its hard to tell with the black and white pic. usually they are green and red since there is some room for tweeking

 

Finally got around to installing all my vinyls I've had for ages...

 

Who did your bed side decals?

 

@CBoy808 , here's his thread. He got back to me with the design within half an hour! He's great!
https://www.tacomaworld.com/threads/custom-made-vinyl-stickers-bedsides.281228/

 

This is the kit, it says AMOUNT OF LIFT: 2.5" Front / 2" Rear, the install shop stated on the purchase order said, 2.5 front and 1.5 rear, so is that considered a 3" lift?

2005-2016 Tacoma 4x4 & 2wd PreRunner - 2.5" Suspension Lift Kit

http://www.suspensionconnection.com/kt09120bk-tacoma-lift.html


Thanks, Im going back tomorrow and show them the pax front tire and ask for a color copy of the specs, I'm just going to keep the lift, just pissed off and ranting here!

 

Yes, 17x9 Fuel Beast