SOLD: FabFours Bumper

All,

I have a FabFours steel rear bumper for sale. I am selling it because I never thought I would be going to a high clearance bumper, but I am. Very hefty and durable bumper, was on my truck for almost 1.5 yrs. No accidents have occurred and no damage to the bumper.

Asking 700$ OBO. Preferred face-to-face (FTF) or shipping will be a buyers expense.

This bumper does work with factory hitch which was a main selling point for when I bought it AND it uses the factory license plate lights!

Black Powder Coating from factory.













EDIT: important detail. I am currently getting my HC bumper made and it will be a few weeks, prob sometime in AUG before it arrives. I will be unable to physically deliver this until that one comes in! I know these aren't cheap and figured posting early would give people a chance to save, making it easier to purchase. Sorry for any inconvenience this provides.

EDIT #2: Removed swing out from deal since it has been purchased already, separately.

 

How close to Gainesville Ga are you

 

About 2.5 hrs away, but can def meet you in between, prob south of ATL.

Im at Ft. Benning (Columbus)

 

EDITed OP

 

I like how I can use factory hitch- though doesn't provide the clearance. How big of tires are on there? Room to weld Jerry can holder?

 

I have a 35" tire on there. I can take a measurement/pic of how much room on each side to see the possibility of jerry cans. I strap them in the bed when I need them so I never considered the can option actually on the swing out.

 

IF (big IF) you decide to separate them, I'd be interested in the bumper and I'm somewhat local to you. I'm in Warner Robins.

 

that is awfully close. I will keep that in mind. If by the time my bumper arrives and installed, if theres no takers I will highly consider it. thanks for the heads up.

 

GLWS

 

thanks

 

There may be room for 1 jerry can on the driver side. I would recommend against putting one on the passenger side due to the swing hinge.

sorry the pic is dark, but due to angle the measurements are slightly off. you have 13" from the end of tire to the taillight/tailgate line. and it is about 10" from tire to the point where the horizontal and diagonal bar meet, right before the latch w/ safety pin. So you're looking at 10" of working room to weld a jerry can holder on it, IF you are looking to modify the swing out.

 

GLWS! Im in the same situation as you (but with a Pelfreybilt standard rear), but just havent made a thread.

What brand HC did you go with?

 

I decided to go with Brute Force. Billy is awesome and IMO, you cant go wrong with him.

 

Also interested in just the bumper if you separate

 

I would take the swing out if you were to seperate have the bumper moths swing out! It's an awesome bumper GLWS

 

you are willing to buy the swing out? without the bumper???

 

Yes I only need the swing out

 

UPDATE: I have sold the tire carrier separate!

The bumper is up for sale by itself now. PM's accepted. Keep in mind I cannot physically hand over the bumper until my new one arrives most likely late august.

Asking 700$ OBO. Prefer NOT TO SHIP, full shipping costs will be at buyers expense (it costs a ton to ship a bumper through commercial shipping companies)

 

If you are still interested in the bumper, let me know. I was contacted in this order:

@KaptainH
@Arcticelf (through PM)
@ziffen
@assaultrecon28

Based off BruteForce timeline, looks like it can go in late Aug/early September. Of course timing is subject to change based off when Billy ships out mine.

 

Gonna pass but GLWS! Preciate it