What have you done to your Tacoma today? 1st Gen Edition

Not sure

 

If you never off road, then probably depending on your wheel backspacing and the exact size 35 you plan on getting.

If you fully cycle your suspension you're going to rub no matter how much lift you have unless you set up your bumpstops up super long or cut into the firewall.

 

I want to try to avoid doing that and regearing so I think I'm going with 33x12.50's

 

Yeah I'm just gonna stick with my 33's lol

 

Youl still have to tub inner fenders. Outer fender and bedsides will be spared some but probably still need trimming on the sides.

 

Good option as well

 

Then why go for the 1" BL?

 

Cause I'm running 31's right now and to keep from scrubbing in the front plus add a little height to the truck

 

Loaded her up with gear, guns, and beer.

 

You don't need the bl for 33s

 

That was the inner seal and just the shot of the back side of it.

Glad it went well Sorry I was MIA all weekend and couldn't answer you sooner.

 

Yea still confused.

Wouldn't do it at all. You don't need too. Just need. A big hammer and a good alignment.

 

installed new passenger side cv axle yesterday. Was gonna change inner and outer tie rods on both sides but got lazy.

 

Converted the lighter to a USB/AUX port.

 

Do they make hybrid bumpers for our 1st gens?

 

Check out @BYJOSHCOOK

 

Fiberglass on.



And then take the bed right off again lol

 

Planning my next steps

Fiberglass front fenders
Relentless DIY front and rear bumpers
my own bed rack that wraps around the camper shell (for mounting gas/tools outside of sleeping area)

 

Wrap around rear or regular?

 

Check my build man. @Bruteforce Fab makes a sick hybrid bumper. Damn good quality for the price which wasn't too bad