NW WA Meet / BS Thread

Probably dielectric grease

 

It had some funny number to it, I wrote it down on a piece of paper somewhere I think. Worst case is you could write to WARN's service department with a generic question.

 

I have a complete set of injectors if you are able to cancel your order. Have coil packs also but they are used and I have never tried them.

 

I wasn't using new tires and washing as an excuse, that's definitely a reason to go wheeling. I have family over from Ireland at the moment, and I'm supposed to go golfing with them one day this weekend before they leave. Still not sure on what day it will be.

 

Unless you will be doing harder trails than we did in 2014, your Runner can make it without a winch.

 

Yeah I'm down. I might knew i few people who also want to go

 

I really want to get out on the trails, Naches, Gallagher, etc., but I torn a CV boot on the last trip. I want to keep these CVs for a rebuild, so I'm planning on keeping them clean.

*Edit: Where should I call around on the Eastside to find a junkyard CV for the '96-'02 4Runner?

 

Went to Surprise Lake today for a little while. Talked my 6yr old boy to go. He likes collecting brass bullet shells, so I helped him grab alot before heading up the mountain. I could tell the water levels were high and the entrance to the lake was rutted out really bad. I never saw it that bad before. I did have to winch it out. I was stuck with my rear tire going back out up the ruts when leaving the lake. Had fun. Carnage was my drivers side rims. Scraped the face on the front rim and curbed the lip and face on the rear rim.
https://youtu.be/bpx6F9d3zOc

 

Who ever is coming to my house pm me and I will send you my address

 

Ha! I think my wife was singing the same song as your son at the same place! How did you do on the ledges after the 2nd switchback? Mud pit is pretty sick. I slide over to the right coming out and had to winch out on the tree in front of it. Did pretty much the same thing to my wheels.

 

Yeah I'm fairly certain id be fine, but it's good insurance anyway, you never know.

I'm in for Gallagher or Liberty on the 30th.

 

You alive dude? Heard some shit is going on over there

 

I purchased a Leer 100XR from Canopy World in Lynnwood on 7/2. It arrived last Friday (7/15) and I just got it installed today! One of the features we bought it for was the ability to lock and unlock the hatch from the inside. So that when we go camping or for any reason have to sleep in the bed, we can do so without people/animals being able to open it on us, and still get out for midnight bathroom runs... However, as I was loading it up for our upcoming weekend, I noticed the latch wasn't the one promised... I will be calling them tomorrow to get that exchanged for the right one. Luckily, I not only work next door to the dealer, but we work with the dealer and send our customers to them as well, so it should be ready by the time I'm off work tomorrow (granted they have the correct latch system in stock)! I definitely recommend them to anyone looking to purchase a topper/shell/tonneau. It is a family-run business and the owners are there open-close. Great people!
Also, sleeping platform is built and installed for the upcoming weekend!!!
I will post pics tomorrow when the sun is out...

 

Sounds just like my kid x3...all we can answer is " yeah..... "haha

 

Did u & yo friend go down that rut by the end?

 

How much did it run you if you don't mind me asking this is my number 1 thing I want done besides lift and tires.?

 

Pay extra to get the doors on the side windows. If you ever go with a swing out carrier your bed access is pretty much a hassle. I'm getting one of my windows replaced with a door type. 375$ per wondow. Going to just do the drivers side of the canopy.

 

Good tip thank you.

 

What shell do you have? I asked a local place here and they told me they couldnt do it.

 

100r..the cheapy