Orange County CAF's: up to no good

Getting there. 8 more tubes and that sucker can drop through the floor to weld up. Probably a good solid month left on it.

I need that time. Just wanna make sure you don't get all motivated when parts show up.

 

Well I mean its not like I've had my nice head gaskets sitting in a box for the last 4 months or anything...

 

Awesome!!! Pretty stoked to see it rockin'n'rollin!

Well since it seems like some of you are out of commission or recouping money from camping/froading to much maybe we can get a city drinking fest going! Lol

 

I'm down for that. Too much working on that truck makes me crazy if I don't get out.

 

Mod day?

 

Thanks for the heads up! I am following these threads but no updates... Doh!

 

I think so. It's a lot of fun to drive

 

I bet it is I would love a little single cab to romp around on

 

Sign me up!

Belching beaver brewery in Vista?

 

Harbor town pub?

 

some asshole at work took one of my really good monitors and replaced it with a really shitty one. they didnt even plug the power or hdmi cable in. whats wrong with people? like dafuq i was using that thank you very much.

 

well problem is there is limited access to this room so it can only be a few people i have looked in the room and its not in here and I am usually alone in here from 6am-1030am-ish then just one other guy till I leave at 430pm and he stays till 6ish so I will have to ask when he gets in.

 

I kinda wish I could like this twice..


Hope everyone is having a wonderful hump day.

 

I would not stand for that shit! Go on the hunt until you find that monitor and take it right off their desk as they're using it.

 

Hey anyone with OEM leaf springs and an add a leaf want to trade for All Pro expo springs??? (View post # 8)
https://www.tacomaworld.com/threads/leaf-springs-oem-almost-new-so-cal.439030/#post-12942956

 

Idk. I asked but have yet to get a reply

 

Tore the rear of the runner apart to do wheel seal and shoes. Noticed bearings are shot. Purchased said bearings and seals etc and asked Toyota if they would press them on the axle for me. Figure what, and hour tops right? Nope, quoted me 4 hours at $125/hr... I laughed hard enough for people to stare. Told the guy I could go buy a press for less than that and I left... I'm supposedly out of town this week lol. So I can't go use the press at my shop. Sumbitch

 

She's stripped bare now and apparently my dog enjoys gear oil. Pretty sure that's not good for him

 

I had the same fucking problem on mine. $100 alone for the seal. What I ended up doing was taking the drum/axle shaft thing (I don't know what the whole thing is called but I'm sure you know what I'm talking about since you took it off) throwing it in the back of the Tundra and taking it to a shop to get pressed. Was an hour labor (what bs that is. Probably took them 20 mins) and another $100 out the door. Did manage to save like 3 hours labor though which was good. Still the most expensive job I've ever had to do on mine though other than the head gasket

Edit: Third most expensive job* had to replace my entire A/C system because previous owner was an idiot and removed the low side hose, ruining the old system. What a pain