What Have You Done To Your 2nd Gen Tacoma Today?

PANEL ASSY. 55421-04020

 

I've always been fond of these! If I didn't find a good deal on my sliders I would've gotten these instead.

 

Also order two push pin clips. Part # 90467-A0001-C0.

 

@nazlax10

 

Awesome, thank you! Is there anyway to reuse the clips from my current assembly? I just broke some clips where the hazard switch assembly mounts and am finally replacing it.

 

If the fabric has come loose from the hard form they may try using spray adhesive. I put sound deadner on my roof as well, there's probably an 1"z1 1/2" gap between the head liner and the roof.

 

I really like the look. I was going with sliders until I got these off a tw member for 150$. Had to snatch them up. Drove 3hrs one way to get them.

 

Did the oil change in the truck and it was well needed. Also added in the Fumoto valve to make oil changes easier as well. Then added the Icon Swaybar spacers to the front sway bar. Finally I took my homemade HiLift bed rail mounts I had made and turned them into a QuickFist mounts for a shovel and an axe and mounted them in the truck.

Overall a good day.

 

Your welcome. It will come with 3 new yellow top clips and yes it comes with a complete hazard bracket that is held in by the 4 small screws. The push pins I mentioned hold the bezal to radio. You should be able to get this for 60.00 bucks.

 

Painted the lower valence last night

 

What did you use? Looks good

 

Plastidip for the win

 

Drilled and tapped the shift knob from my old '66 vw split window westphalia to fit my truck
Next it goes to get airbrushed fresh again.



The van was in the movie Sideways!
Excuse the pic, I photo'd the tv!

 

I like it ! That's Old School !!

 

Just practice and practice even my practice looks like crap! Haha down hill weld and walking the cup. I would like to weld my own sliders tho

 

That looks great though!!

 

Na this pass is perfect. With a Double pass this would be strong as fu**

 

long day i tackled the front suspension by myself no biggie until i realized all the hardware was rusted bad. soaked it with penetrating oil and tore it all apart. i removed the stock strut with the spacer lift and installed billy 5100's set at 0 with eibach coils the 112620 620lb coils. got everything put together and went for a test drive boy did it ride great. came back and measured it and i lost 1 1/2" of lift in the front. the rear was already 1 1/2" higher than the front now it was three. pulled it back into the garage and tore it back apart tomorrow i'll get the billies set to the first notch .85 marie at hs says will give me an inch we'll see. dissappointing a little i wnted to leave the billies at zero to get the full benefit out of them hoefully the little bit of preload at .85 won't make much difference

 

Sounds like a nice day of work! Are you gonna stick with the 285